Kramer Electronics PIP-300 Displaying the Layers in the PIP Mode, Press Input button 1, or

Configuring and Operating your PIP-300

7.2 Displaying the Layers in the PIP Mode

To display a picture in picture on the screen, do the following:

1.Select an input.

2.Select the PIP mode.

3.Size and position each layer as desired1.

4.Press an INPUT button to bring forward that input on the screen.

7.2.1Selecting a Different Channel as the Background

In the following example, Channel 2 replaces Channel 3 as the background.

A

The current screen shows:

￿￿Channel 3 in the background (PIP SIZING: 1:1)

￿￿Channel 1 in front (PIP SIZING: 1:16)

￿￿Channel 2 in front (PIP SIZING: 1:4)

B	Select Channel 2 and size it to 1:1 as follows:
	A. Press INPUT 2
	B. Press the LAYER button (or follow steps 1 to 3)
	1. Press ENTER
	2. Press ENTER again to select MODE
	3. Scroll down to PIP and press ENTER
	C. Press ENTER to select PIP SIZING
	D. Press ENTER to size to 1:1
	The current screen shows:

￿￿Channel 2 in front (PIP SIZING: 1:1)

￿￿Channels 1, and 3 are behind, unseen

C

Press INPUT button 1, or 3

The current screen shows:

￿￿Channel 2 in the background

￿￿Channels 1 and 3 in front

Size and position channels 1 and 3 as desired

1 Only one channel can be sized to 1:1, the others should be smaller in size or OFF (see Table 6)

17