Kramer Electronics PIP-200xl user manual Connecting the PIP-300 Picture in Picture Inserter

Connecting the PIP-300 Picture in Picture Inserter

6 Connecting the PIP-300 Picture in Picture Inserter

To connect your PIP-3001, as the example in Figure 3 illustrates, do the following2:

1.On the INPUT 1 set3 connect4:

￿￿An s-Video source to the Y/C INPUT 4p connector (for example, an s-Video player 1)

￿￿A component video source to the Y, B-Y, and R-Y INPUT BNC connectors (for example, a BETACAM video player 1)

2.On the INPUT 2 set4 connect a composite video source to the CV INPUT BNC connector (for example, a composite video player 2)

3.On the INPUT 3 set4 connect a composite video source to the CV INPUT BNC connector (for example, a composite video player 3)

4.Connect the OUTPUT connectors5, as follows:

￿￿The CV OUTPUT BNC connector to the composite video acceptor (for example, a composite video display)

￿￿The Y/C OUTPUT 4p connector to the s-Video acceptor (for example, an s-Video display)

￿￿The Y, B-Y, and R-Y OUTPUT BNC connectors to the component video acceptor (for example, a component video projector)

5.Connect a PC or other controller, if required (see section 6￿ .1).

6.Connect the power cord6 (not illustrated in Figure 3).

1 From this section on, all the information is relevant to both the PIP-200xl and the PIP-300 machines, unless noted otherwise 2 Switch OFF the power on each device before connecting it to your PIP-300. After connecting your PIP-300, switch ON its power and then switch on the power on each device

3 PIP-200xl has two sets of inputs, the PIP-300 has three sets of inputs 4 You do not have to connect all the inputs in each set

5 If only one output is required, connect that output to the PIP-300, and leave the other outputs unconnected 6 We recommend that you use only the power cord that is supplied with this machine

9