Cannon 300II manual Operation panel, Negative/Positive key

■ BEFORE YOU BEGIN ... ■

Operation panel

This is a summary of the keys on the operation panel.

1 Negative/Positive key	Three settings are available:
	(	) In negative film mode produces positive output from nega-
		tive film images.
	(	) In positive film mode, produces positive output from posi-
		tive images.
	( A ) In automatic mode, selects the mode based on the type of
		film detected.(➞P.35)
2 Trimming/Border key	Use this key to trim the image to be scanned or to remove the
	black border around the image.(➞P.36)
3 Brightness indicator	Shows the brightness adjusted using the brightness adjustment
	key.
4 Brightness adjustment keys	Use the or key to adjust brightness of the image manually,
	or the use AE key to adjust it automatically. In the DMP mode,
	this applies to brightness for printing.
5 Print/Error Display	Displays the number of prints (01 to 99) in case of the Reader-
	Printer mode. Also displays error message(User and Service
	releated).
6 Print number setting key	Use these keys to set the number of prints to make for each
	image in the Reader-Printer mode or the DMP mode (➞P.11).
	Also use them to set various settings or confirm the SCSI ID of
	the scanner.
7 Clear/Stop key	Stops scanning or resets the number of prints. Also defines an
	area for trimming, or defines a specified time for the power
	saver mode.
	When the scanner is connected to the Fileprint 470 and used in
	the DMP mode, this key is also used to switch to the cassette
	select mode (➞P.38).
8 Start key	In the case of the Scanner mode: press this key to start scan-
	ning with the “Panel Start” set to on in the application, or to
	start scanning in the Reader-Printer mode (➞P.11).
	In the case of the DMP mode: press this key to start printing.
	The Print/Error display stays blinking from the time the key is
	pressed until the time scanning begins.

15

MS 300_english.p65 15 07.5.14, 10:14