Cannon 300II Hi-speed scanning, Scanning resolution, Cleaning mode, Switching the operation modes

■ USER MODE ■

• Default of the power saver mode at factory shipping

is set to so that the unit switches into the power saver mode if not operated more than 15 minutes.

•The power saver mode can be canceled by any key operation.

•When the FS Controller I is attached, the unit can- not switch into the power saver mode.

Hi-speed scanning

This feature is available in the DMP mode and enables you to speed up scanning by simplifying the startup operation.

: Normal mode (set at the factory before shipping) : Hi-speed scanning mode

In the hi-speed scanning mode, the scanner delivers printouts of the images upside down.

Scanning resolution

When using the DMP mode, you can select one of the following scanning resolutions.

: 600DPI

: 300DPI (set at the factory before shipping)

Cleaning mode

This mode is enabled when the scanner is connected to the Fileprint 470 and used in the DMP mode so as to clean the fixing rollers of the printer. (➞ P.45 “Cleaning mode”)

: Normal mode (set at the factory before shipping)

: Cleaning mode (Cleaning paper: A4 sized)

: Cleaning mode (Cleaning paper: Letter sized)

You need to prepare a sheet of paper of the size se- lected for cleaning and print the cleaning pattern on the paper before you start cleaning the fixing rollers.

Switching the operation modes

This feature is enabled when the optional DMP board is installed in the scanner so as to switch to either of the following modes.

: Scanner mode

: DMP mode (set at the factory before shipping)

The MS300II can be used as a scanner even if the operation mode is set to the [DMP mode]; however, the Reader-Printer mode will be disabled in this case. To enable the Reader-Printer mode, be sure to switch to the [Scanner mode].

41

MS 300_english.p65 41 07.5.14, 10:14