Fujitsu C150-E146-02EN manual Repositioning the Shipping Lock

Page 29

Repositioning the Shipping Lock

To keep the scanner from being damaged during shipping, the carrier unit is fixed with a Shipping Lock. After placing the carrier unit where it will be installed, change the position of this Shipping Lock as explained below.

qPlace the image scanner on the edge of the desktop so that the left side of the scanner (where ADF is attached) extends from the desktop. Do not set the image scanner upside down or on its side.

CAUTION

Do not extend the scanner more than 20cm (8 in.) from the desk.

Good Bad Bad

less than 20cm (8 in.)

wRemove the shipping lock from position A. Then, install the shipping lock at position B.

Front side

Front side

Enlarged

ADF side

 

Bottom view

 

Shipping Lock (Position for

 

storage, position for shipment)

 

Enlarged section A enlarged

ADF side

 

Shipping Lock (Position for operation)

B

A

Shipping Lock (Position for shipment)

CAUTION

Before moving or storing the scanner, make sure that the shipping lock is set to the shipment position to prevent possible damage. Before setting the shipping lock, make sure that the carrier has been returned to the home position.

2-4

Image 29
Contents M4097D Image Scanner M4097D Image Scanner Page Page Iii Important Note to Users Shooting PrefaceConventions Contents Declaration of Conformity Viii Terms Index Components Checking the Components Units Units and AssembliesFunction Assemblies Arrangement Operator PanelLED Button/LED FunctionName of the button Function LED Counter Function Counter DisplayOperation status Power-onHopper empty Temporary errorAlarm Page Page Installation and Connections Precautions Inspection Fujitsu Limited Repositioning the Shipping Lock Cable Connections Turning the power switch offConnecting the power cable Connecting the interface cables Mounting the Stacker Setting the Scsi ID and the Scsi Terminator Page Page Operating Instruction Turning the Power On Waking up the Scanner from the Low Power Mode Manual Feed Mode Setting ADF Loading Documents on the ADFMore than 30mm Feed direction ABD Max 8mm Documents are expelled into the stacker for removal Loading Documents on the Flatbed Loading Documents Larger than the Document Bed Reading a Page from a Thick Book Page ADF Document Specification Scanner Maximum Minimum M4097D Document SizePrecautions Paper weightDocument Quality Document typePage ADF ADF Document Feeder CapacityAreas not to be Perforated Grounding Color Areas Double Feed Detection Condition Job Separation Sheet Scanner Specifications Specification Remarks Basic Product SpecificationMH/MR/MMR SCSI-2Specification Installation SpecificationDimensions Page Consumables and Options Consumables Name Specification RemarksIPC-4D OptionsName Remarks Video Interface Option How to Install the Video Interface Option BoardPage AT2 Without IPC With IPC-4D Descreption OptionAT1 Parameter Description Parameter Description IPC-4D Option Setup Mode Activating the Setup Mode Contents of the Setup Mode ON/OFF Setting double feed detection Paper Thickness Setting double feed detection Paper Length Setting IPC pre-set mode Setting pick start time Reset of abrasion counterSetting time-out limit Page IPC Status Display Scsi ID SettingScsi Terminator Setting Low Power Mode Setting Select Interface Display TPS Board ID Number Page A4 size Automatic start mode manual start modeA5 size A6 sizeEquipment Error Duplex reading modeBit DensityFiltering Error diffusionFront-side reading = Front-side scanning Halftone processingLinedrawing mode IPC preset modeManual Feed mode = Manual Mode Image processingPhotograph mode White level follower OFF Manual start mode automatic start modePhoto mode = photograph mode Mirror imageSimplex reading mode Setup modePortrait orientation Paper counterTime-out limit TerminatorThird Party Interface GL-8 IPC IndexSCSI-ID Page IN-4 IN-5 This manual uses recycled paper