Fujitsu C150-E146-02EN manual Contents of the Setup Mode

Contents of the Setup Mode

This section describes the contents of the setup mode.

No	Item	Description	Selectable	Default
			parameters
1	Double feed check	Specify the double feed detedtion. Double		No
		feed is detected by checking the document
		length and/or paper thickness.**
2	Length check	Specify the document length to enable	Tolerance:	No
	=No/10/15/20 mm	double feed detection set the document	No/10/15/20mm
		length.
3	IPC pre-setting	Scanner automatically sets the recom-	Document:	No
		mended reading parameters. 3 sets of	No
		parameters are available when IPC-4D is	Sharpen Darken
		not installed.	Charactor Copy
			Quality
4	Resetting of abrasion	Reset abrasion counter.	-	-
	counter
5	Pick start time	Specify the time from document Insertion	Time:
	setting	to the start of picking. User can select	0.2 to 29.8 sec	1.0 sec
		most comfortable Pick start time for the
		job.
6	Time-out limit setting	Specify the time the scanner waits for next	Time:
		ducument insertion after last document	27 values from	30 sec
		scanned.	1 to 1999 sec
7	ADF front offset	Specify the horizontal and vertical offset of	Offset:	Offset:
	setting*	the front side image by ADF.	H:-2 to +3mm	H: 0 mm
			V:-2 to +3mm	V: 0 mm
8	ADF back offset	Specify the horizontal and vertical offset of	Offset:	Offset:
	setting*	the back side image by ADF.	H:-2 to +3mm	H: 0 mm
			V:-2 to +3mm	V: 0 mm
9	Flatbed offset setting*	Horizontal and vertical offset of the FB	Offset:	Offset:
		image is specified.	H:-2 to +3mm	H: 0 mm
			V:-2 to +3mm	V: 0 mm
10	IPC status display	The type of IPC option (IPC-4D) is
		displayed.
11	SCSI ID setting	SCSI ID is selectable.	SCSI ID:
			0/1/2/3/4/5/6/7	5

7-2