Fujitsu C150-E146-02EN manual Setting the Scsi ID and the Scsi Terminator

Page 33

Setting the SCSI ID and the SCSI Terminator

The default of SCSI ID is 5. SCSI ID is set by Setup mode of operator panel. The procedure to change SCSI ID is;

1Turn the power ON by pressing “I” side of the power switch (see Figure 1.1). The scanner displays “Scanner Ready” on the lower line of LCD.

2Then press “Next” button. The scanner displays “Mode select 1”.

3Then press “Next” button twice. The scanner displays “Mode select 2” meaning that setup mode is ready.

4Then press “Enter” button several times. The scanner displays as follows.

5Press “Next” around times, then the scanner displays “SCSI ID” on the upper line of the LCD.

6Select SCSI ID by pressing “ ”or “” button, and press “Enter”. (SCSI ID is set.)

7Press “Exit” to return to “Scanner Ready” screen if you don’t Need to change terminator.

NOTICE

If no other devices are using the same SCSI ID, the scanner ID does not have to be changed.

NOTICE

The new ID does not take effect until the system power is turned on again.

2-8

Image 33
Contents M4097D Image Scanner M4097D Image Scanner Page Page Iii Important Note to Users Shooting PrefaceConventions Contents Declaration of Conformity Viii Terms Index Components Checking the Components Units Units and AssembliesFunction Assemblies Arrangement Operator PanelButton/LED Function Name of the button Function LEDLED Counter Function Counter DisplayOperation status Power-onHopper empty Temporary errorAlarm Page Page Installation and Connections Precautions Inspection Fujitsu Limited Repositioning the Shipping Lock Turning the power switch off Connecting the power cableCable Connections Connecting the interface cables Mounting the Stacker Setting the Scsi ID and the Scsi Terminator Page Page Operating Instruction Turning the Power On Waking up the Scanner from the Low Power Mode Manual Feed Mode Setting ADF Loading Documents on the ADFMore than 30mm Feed direction ABD Max 8mm Documents are expelled into the stacker for removal Loading Documents on the Flatbed Loading Documents Larger than the Document Bed Reading a Page from a Thick Book Page ADF Document Specification Scanner Maximum Minimum M4097D Document SizePrecautions Paper weightDocument Quality Document typePage ADF ADF Document Feeder CapacityAreas not to be Perforated Grounding Color Areas Double Feed Detection Condition Job Separation Sheet Scanner Specifications Specification Remarks Basic Product SpecificationMH/MR/MMR SCSI-2Specification Installation SpecificationDimensions Page Consumables and Options Consumables Name Specification RemarksOptions Name RemarksIPC-4D Video Interface Option How to Install the Video Interface Option BoardPage Without IPC With IPC-4D Descreption Option AT1AT2 Parameter Description Parameter Description IPC-4D Option Setup Mode Activating the Setup Mode Contents of the Setup Mode ON/OFF Setting double feed detection Paper Thickness Setting double feed detection Paper Length Setting IPC pre-set mode Setting pick start time Reset of abrasion counterSetting time-out limit Page Scsi ID Setting Scsi Terminator SettingIPC Status Display Low Power Mode Setting Select Interface Display TPS Board ID Number Page A4 size Automatic start mode manual start modeA5 size A6 sizeEquipment Error Duplex reading modeBit DensityFiltering Error diffusionFront-side reading = Front-side scanning Halftone processingLinedrawing mode IPC preset modeManual Feed mode = Manual Mode Image processingPhotograph mode White level follower OFF Manual start mode automatic start modePhoto mode = photograph mode Mirror imageSimplex reading mode Setup modePortrait orientation Paper counterTerminator Third Party InterfaceTime-out limit GL-8 IPC IndexSCSI-ID Page IN-4 IN-5 This manual uses recycled paper