1.In <<SETUP MODE>> initial screen, press
ENTER .
The <<SETUP MODE>> menu screen (Settings or Paper Length Check) appears.
NOTE
The “Settings” screen does not appear and the “Paper Length Check” screen first appears when your scanner is not controlled through the video or TP interface.
2.Press twice.
The <<SETUP MODE>> menu screen (Paper Thickness Setup) appears.
3.Press ENTER .
The paper load prompting screen appears, requesting adjustment paper.
4.Select thickest paper used for your jobs and put the paper on the hopper.
5.Press ENTER .
The “Adjusting!!” message appears. The scanner lifts the hopper, feeds the paper, adjusts the sensing level of the sensor, and saves its value.
After adjustment, the sheet is ejected and the “Finished!!” message appears for two seconds, then the LCD returns to the <<SETUP MODE>> menu screen (Paper Thickness Setup).
If an error (for example,
6.Press CANCEL two times.
The LCD returns to the Ready screen.
<<SETUP MODE>>
<<SETUP MODE>>
Settings
<<SETUP MODE>> Paper Length Check
<<SETUP MODE>>
Paper Thickness Setup
Paper Thickness Setup Set the adjustment paper
Paper Thickness Setup
Adjusting!!
Paper Thickness Setup
Finished!!
<<SETUP MODE>>
Paper Thickness Setup
Ready