Fujitsu C150-E141-02EN manual Function key

Function key

This function allocates setup functions to F1 , F2 , and F3 buttons. You can allocate up to three setup functions.

NOTE

• You cannot use this function when the setup mode is brought by pressing MENU in the Ready status.

•You cannot allocate the following functions: Interface, IPC-3 mode, TP_IF Baud Rate, RS232C Baud Rate, SCSI ID, Product ID, Setup Mode Lock, and Function Key itself.

Allocatable setup functions and other special functions					Remarks
Setup functions noted above
START key					START: starts the operation stopped by EJECT and
EJECT key					sends data to the host computer.
(Default: Undefined)					EJECT:stops operation and ejects the paper in the
					transport unit.
The	F1 ,	F2 ,or	F3	button can be used as a shortcut key which enables you to access

the allocated setup function just by pressing the button whenever the scanner is in the Ready state. This function is valid even in the setup mode lock state (refer to the next function). However, the

F1	,	F2 , and F3	buttons are invalid in setup, browse, and test modes.
The following is an example of operation when you allocate START and EJECT keys to the				F1
and	F2	buttons respectively.

1.In <<SETUP MODE>> initial screen, press

ENTER .

The <<SETUP MODE>> menu screen (Settings or Paper Length Check) appears.

NOTE

The “Settings” screen does not appear and the “Paper Length Check” screen first ap- pears when your scanner is not controlled through the video or TP interface.

<<SETUP MODE>>

<<SETUP MODE>>

Settings

<<SETUP MODE>> Paper Length Check

6-43