Toshiba IK-1000 instruction manual Connection

Page 10

4. CONNECTION

Lens

Camera body

Monitor

VIDEO terminal

Coaxial cable of 75Ω

DC IN 12V terminal

DC 12 V power supply

Cautions

•When installing the camera, unplug the power source of the camera and all connected equipment.

•Please use a monitor which has BNC or S-Video input.

•A coaxial cable of 75Ω or S-Video cable is needed to connect a video monitor etc.

•For DC power supply connecting to DC 12 V terminal, use a power supply with the specifications described below.

Power supply voltage:	DC12V ±10%
Current rating:	2.0 A or more
Ripple voltage:	50 mV (p-p) or less
Connector:	HR10A—7P—4S by HIROSE Electronics Co., Ltd.
	Pins 1, 2: +12V
	Pins 3, 4: GND

(1)Install the lens to the camera body. For available lenses, refer to the item “5 LENS ADJUSTMENT.”

(2)Connect a coaxial cable from the VIDEO terminal to the video input terminal of the video monitor etc.

(3)Connect equipment, turn on the power supply to the camera, and then turn on the power to the equipment.

(4)Adjust the lens by referring to item 5, obtain the best camera performance.

- 10 -

Image 10

Contents Table of Contents CCD Color CameraPage Important Safeguards Field Installation Operating ambient temperature and humidity On installation, observe the following mattersInstall the camera in a location free from noise Outdoor installationNames and Functions When cleaning the cameraComponents Handling of the protection capPage Setting screens 4Tripod setting hole Connection Available Lens Lens AdjustmentHow to Adjust Iris Automatic iris lensHow to Adjust Back Focus and field angle Operation Sens FunctionAuto Mode Manual modeWhite Balance ONE Push WB One Push White BalanceScene files Manual Manual white balanceMode Setting by on Screen Display Using the ScreensItems that can be set on screen display Sens sensitivity setting When Changing Setting of Auto Sens ModeChanging flicker correction Page Bold face on the diagram shows a detection area Data UP When Changing Settings of Manual mode Synchro. Scan mode Decrease in red Data Down WHT BAL White BalanceData UP Increase in red Data UP Increase in blueBold face on the diagram shows a detection area Mode ATW When Changing Settings of Manual Manual White Balance Mode Process Process Option Option Data UP Increase of gain Decrease of gain Data Down Troubleshooting Stop of useExternal View Specifications ManuPage Page Page Page Page One 1 Year