perform this function.
Focus Mode
There are three modes to choose, the default is ‘Auto’.
Manual: Press NEAR and FAR to control focus on the PTZ Control interface.
Auto: The Auto mode automatically adjusts the focus position to the best of the picture in a center. Also, change near/far to Focus Near and Focus Far on the PTZ Control interface. After this change, camera became ‘Manual’ mode once, and getting back ‘Auto’ mode if you click PTZ operation.
Zoom Trigger: Under this mode, camera will remain as ‘Manual’ mode unless it receives zoom in or zoom out signal, and after the designated action it will back to ‘Manual’ mode.
Focus Sensitivity
You can set is as Normal (default) or Low.
When the lighting level is low, the Auto Focus function does not take effect. At that time, you can set to ‘Low’.
Focus Correction
Set ‘Standard’ normally. If you light the IR illuminator and the camera was unfocussed, set to 'IR Light'.
Set DAY/NIGHT function. Move the cursor to select the AUTO (default), Day, or Night mode.
AUTO: The IR Cut filter can be disengaged automatically to increasing sensitivity in low light environments.
NOTE: Although hunting may occur under the conditions of specific brightness, it is not a malfunction.
Day: You can force the camera to stay in DAY (COLOR) mode.
Night: You can force the camera to stay in BW (NIGHT) mode.
Zoom Limit
You can choose x20(default, optical), x40(x20 optical + x2 digital), x80(x20 optical + x4 digital), x160(x20 optical + x8 digital), x240(x20 optical + x12 digital).
DNR
You can configure the noise reduction related setting from 0 to 5 and reduce noise on the screen. ‘0’ means OFF and ‘5’ is the maximum. (Default is 3.)
WDR(Wide Dynamic Range)
23