Toshiba Network Camera, IK-WP41A user manual FTP Server Settings Server 1

a) Recording by Alarm In

Perform "Alarm input setting" first,

Then record in the following sequence:

￿Pre-recording: Set the number of images to be recorded before an alarm occurs. Images of the moment when an alarm occurs are not included. You can set Pre-Recording as 0, 3, 5, 10 frames.

￿Post-Recording: Set the number of images to be recorded immediately after a motion occurs. Images at the moment when a motion occurs are not included. You can also set Pre-Recording as 0, 3, 5, 10, 20, 60, 120 frames.

￿Recording Interval: Set a time interval for motion recording.

￿Recording File Name: Set the file name where the name is to be stored on the server.

￿Server Path: Enter the data path where the data is to be stored on the server.

b)Recording by Motion

Perform "Motion Detection Setting" first,

All the other settings are same as recording by alarm as above.

NOTE:

When events occur frequently, Pre-Recording, Post-Recording, and Recording Interval may be unable to be recorded as setup.

2. FTP Server Settings - Server 1 and 2

Please follow your FTP setting to setup FTP server name, Login ID, Password, FTP port number, FTP mode, and FTP connecting method.

￿FTP server name: Input a server name or address.

￿Login ID: Limited only to users who have authority to access the server.

￿Password: Input the registered password associated with Login ID.

￿Password (Confirm): Re-enter the password.

36