Toshiba Network Camera, IK-WP41A user manual Alarm In1 to Alarm In6

Multicast Address	Specify the multicast address (e.g. of the switch or router)
H264	Select “Unicast” or “Multicast”. In “Multicast” mode camera
Transfer Type	supports IGMP.
	Specify the port number you	Specify the port number you
H264 RTSP	would like to use for RTSP	would like to use for RTSP
Port Number	protocol, from 1 to 65530,	protocol, from 1 to 65530,
	default is 554.	default is 556.
	Specify the port number you	Specify the port number you
H264 Video	would like to use for video	would like to use for video
Port Number	streaming, from 1 to 65530,	streaming, from 1 to 65530,
	default is 5000	default is 5010

NOTE:

￿Since this camera uses a HD sensor, an Image not over 480P is displayed vertically.

￿Max. Connections of real time:

￿Up to 3 simultaneous Unicast users at 1080P.

￿Up to 10 simultaneous Unicast users.

Alarm

There are 6 alarm input terminals and 1 output terminal on the base of the camera and each alarm contain 32 preset actions, when alarm 1-6 is triggered, the camera will immediately move to the preset position.

￿Alarm In1 to Alarm In6

￿Input Type: Set the alarm contact type as Normal Open or Normal Close. For alarm input type, the active state is shown on the page 19 in the QSG.

￿Actions: Specify the action to be taken when alarm is triggered. No action will be taken (but an alarm is logged).

30