Installation
Hardware Installation
Please verify that your product package contains all the accessories listed in the Package Contents listed on page 7. Depending on the user’s application, an Ethernet cable may be needed. The Ethernet cable should meet the specs of UTP Category 5e or higher.
Hardware Installation is shown in the Quick Start Guide(QSG). Please refer to page 10 of the QSG.
Network Deployment
In this user’s manual, “User” refers to whoever has access to the Network Camera, and “Administrator” refers to the person who can configure the Network Camera and grant user access to the camera.
Network Deployment is shown in the Quick Start Guide(QSG). Please refer to page 19 of the QSG.
Micro SD/SDHC Card Installation
NOTE:
Card slot is in the inside of a camera. You should turn off all power before installation.
When installing the SD/SDHC card, be careful not to generate static electricity at the time.
When installing the SD/SDHC card, don’t touch the internal wiring.
Check if the
1.The dome cover and the internal black cover are removed.( Refer to 10 pages of QSG.)
When you remove the internal black cover, remove the two screws indicated by the arrows.
11