Vivotek IP7152, IP7151 manual Electromagnetic Compatibility EMC, Liability

Page 106

Electromagnetic Compatibility (EMC)

This device compiles with FCC Rules Part 15. Operation is subject to the following two conditions.

•This device may not cause harmful interference, and

•This device must accept any interference received, including interference that may cause undesired operation.

USA - This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a partial installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

--Reorient or relocate the receiving antenna.

--Increase the seperation between the equipment and receiver.

--Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

--Consult the dealer or an experienced radio/TV technician for help.

Shielded interface cables must be used in order to comply with emission limits.

Europe - This digital equipment fulfills the requirement for radiated emission according to limit B of EN55022/1998, and the requirement for immunity according to EN50082-1/1992.

Liability

Vivotek Inc. cannot be held responsible for any technical or typographical errors and reserves the right to make changes to the product and manuals without prior notice. Vivotek Inc. makes no warranty of any kind with regard to the material contained within this document, including, but not limited to, the implied warranties of merchantability and fitness for any particular purpose.

Image 106

Contents Page Technical@vivotek.com Before You Use This Product Table of Contents Ddns Rtsp SDP Package Contents Installation Hardware installationSoftware installation 6 5 4 3 2Check Network Settings Initial Access to the Network CameraAdd Password to prevent Unauthorized Access Installing plug-in How to UseAuthentication 886-2-82455282 886-2-82455532 Primary user’s capability Main Screen with Camera View886-2-82455282 886-2-82455532 886-2-82455282 886-2-82455532 Here is the layout in Firefox when it is Jpeg streaming Digital Zoom MP4 RecordingSnapshot LanguageClient settings 886-2-82455282 886-2-82455532 Fine-tuning for Best Performance Administrator’s capabilityDigital output For Viewing by Mobile Phone For Best Real-time Video Images Protect Network Camera by passwords Opening accounts for new usersBuild a security application Software revision upgrade Definitions in Configuration System parameters Security settings 886-2-82455282 886-2-82455532 Network settings Network typeHttp Rtsp Streaming886-2-82455282 886-2-82455532 Url http//Network Camera/setup/network.html Wlan Settings IP7152 only Tkip AES Ddns Access List Audio and Video Video SettingsVideo orientation Audio settings Url http//Network Camera/setup/audiovideo.htm Image Settings Privacy Mask 886-2-82455282 886-2-82455532 CCD Settings Motion detection Url http//Network Camera/setup/motion.htm Camera control 886-2-82455282 886-2-82455532 Camera control panel doesn’t show up in `Fixed Camera’ mode Preset position Custom command Application Event Server 886-2-82455282 886-2-82455532 Media Recording Url http//Network Camera/setup/recording.htm System log Viewing system parameters Url http//Network Camera/setup/parafile.htm Maintenance Url http//Network Camera/setup/maintain.htm Troubleshooting Status LEDOverview URL commands of the Network CameraStyle convention General CGI URL syntax and parameters Security levelGet server parameter values Method GET/POSTSet server parameter values Parameter pairUpdate Available parameters on the server Valid Values DescriptionNTP server 886-2-82455282 886-2-82455532 886-2-82455282 886-2-82455532 GMT Integer Inactive status Group security Name Value Multicast video port Build-in Set bit rate in bps when choose Cmos Window Wini0~2height Height Motion Providerhos Logemerg Name Value Security Description 886-2-82455282 886-2-82455532 Videoincodec Audiooutcodec Detection Parameter Value Security Description Port to connect the server Video clip in seconds Drive the digital output Query status of the digital input Query status of the digital output Capture single snapshot QualityAccount management System logs Upgrade firmware IP filteringRtsp SDP 101 Technical specifications System and HardwareImage settings Technology License Notice MPEG-4 AAC Technology MPEG-4 Visual TechnologyElectromagnetic Compatibility EMC Liability