FARGO electronic 970627-510489-(04) manual Supply Take-up

Supply

Take-up

3.Place the supply end of the ribbon in between the two black ribbon drive hubs located towards the rear of the printerÕs interior. Insert the supply end so that the ribbon is fed from underneath the ribbon roll. Hint: the ribbon drive hub on the right-hand side of the printer is spring-loaded. Use the end of the ribbon core to push in this ribbon drive hub as ribbon is inserted.

Ribbon	Spring-loaded
drive hubs	ribbon drive
	hubs

4.Place the take-up end of the ribbon in between the front ribbon drive hubs. When installed properly, ribbon will feed from underneath the supply end of the ribbon roll, up and over the top of the take-up end.

Photo Ribbon and Paper 4