Specifications | Philips SVA102 instruction

Specifications 41

Video Heads

Two heads

Video Signal

EIA standards; NTSC color

Antenna

VHF/UHF – 75 ohm external antenna terminal

VHF Output Signal

Channel 3 or 4 (switchable) 75 ohms unbalanced

Power Requirement

120V AC; 60Hz

Power Consumption

14W

Operating Temperature

41°F (5°C) to 104°F (40°C)

Relative Humidity

10% to 80%

Weight

5.5 lbs. (2.5 kg.)

Dimensions

14-3/16” (W) x 3-1/16” (H) x 9-3/16” (D) (360mm x 92mm x 230mm)

Tuner Broadcast Channels

VHF 2-13, UHF 14-69

Cable TV Channels

2-13

Midband: A – 1

Superband: J – W

Hyperband: A-5 – A-1

Special Channel: 5A

Ultraband: 37 – 94, 100 – 125

NOTE: Designs and specifications are subject to change without notice.

Image 41

Philips SVA102 owner manual Specifications

Contents

Video Cassette Recorder For Customer Use Warranty Verification Introduction FeaturesSafety Precautions Table of Contents Using the Remote Control Putting Batteries in the Remote ControlVCR maintenance Replace the battery compartment lid Disconnect the antenna or cable from your TV Hookups Without a Cable Box/Direct Broadcast System Plug in the TV and the VCR Hookups Without a Cable Box/Direct Broadcast System cont’d Recording/Viewing Any Channel Hookups With a Cable Box/Direct Broadcast SystemConnections Select the channel you want to watch at the Cable Box/DBS Recording One Channel/Watching Another Hookups With a Stereo TV 2Turn on the TV Turning on Your VCR Automatic Channel Setup Adding/Deleting Channels Automatic Channel Setup cont’d Follow the steps below to set your VCR’s clock. Make sure Setting the Clock 96-7 Setting the Clock cont’d Language Selection Press the Counter RESET/EXIT button On-Screen Status Displays OFF mode Press the Display button once Count modePress the Display button once Clock mode Power Button Remote Control ButtonsNumber Buttons Rental Selector Button Eject Button Counter RESET/EXIT ButtonAuto Repeat Button CLOCK/COUNTER Button VCR Display Panel Front Panel Rear Panel AC Power CordAudio OUT Jack Video OUT Jack Read and follow the steps below to play a tape Playing 1Turn on the TV Insert a tape Recording Stopping an OTR Starting an OTR Program Number → Once Daily Weekly Timer Recording Repeat the procedure in to set the recording’s end time Timer Recording cont’d 4Press the Counter RESET/EXIT button to exit Correcting a Timer Recording Cancelling a Timer Recording Select Auto Return Auto ReturnPress the Play button or the Stop button repeatedly to To return to the channel being recorded, use the TV Press the VCR/TV button on the VCR remote control toPut the VCR in VCR position. The VCR/TV light will appear To stop recording, press the Stop button RF coaxial cable Rerecording Tape Duplication Repeat Play Forward and Reverse Searching SP/LP/SLP Special Effects PlaybackSuper High Speed Searching LP/SLP Viewing a Still Picture Rental Play Press the Play button to watch the tape Real-Time Counter Memory Automatic Playback Features Helpful Hints Helpful Hints cont’d Cable Box/DBS Output Channel Channel 3 or Glossary Specifications Video Cassette Recorder Limited Warranty Index Supplied Accessories