●Before turning on your VCR, make sure there are batteries in the remote control and the VCR and TV are connected (see pages
●You can not set up channels if you are using a Cable Box/DBS.
●The instructions on this page only work when you turn on the VCR for the first time. If there is a power failure or if the VCR is unplugged for more than one minute, you may need to repeat the instructions on this page.
1
Press the POWER button. The POWER light and the VCR/TV light will appear.
2
Turn on the TV. Set it to the same channel as the CH3/CH4 switch on the back of the VCR. The menu shown
below will appear.
LANGUAGE SELECT |
|
→ ENGLISH | [ON] |
ESPAÑOL |
|
3
Press the PLAY button or the STOP button to select ENGLISH or ESPAÑOL. [ON] will appear beside your choice.
4
Press the F.FWD button or the MENU button. TUNER SET
UP will appear on the screen.
TUNER SET UP
5
Press the MENU button, the F.FWD button, or the REWIND button to begin automatic channel setup. TUNER SET UP will flash on the screen. When channels are set up, the TV will go to the lowest channel available.
The VCR will memorize all available channels, so when you use the CHANNEL o/p buttons, you’ll only scan through channels that you receive.
Turning on Your VCR 11
2Turn on the TV.
1
POWER | VCR/TV | EJECT |
1 2 3
4 5 6
7 8 9 CHANNEL
|
| 0 |
| +100 |
|
|
| SPEED | RENTAL |
| AUTO | CLOCK/ |
|
| SELECTOR | REPEAT | COUNTER | 4 | ||
|
| |||||
5 | MENU DISPLAY | EXIT | COUNTER | |||
|
|
| RESET | MEMORY | ||
REWIND |
| / PLAY | F.FWD | |||
| RECORD |
| / STOP | PAUSE/STILL |
| |
3
Helpful Hints
•If you do not see any
•If you try to set up channels when there is no antenna or cable connect- ed to the VCR, programming will appear to take place. Eventually, TUNER SET UP will appear on the screen steadily, and channel program- ming will stop. Connect an antenna or cable to the ANT(enna) IN jack of the VCR, then press the MENU but- ton, the F.FWD button, or the REWIND button again. Channel pro- gramming will begin again.
