Adcom GTP-760 owner manual Video Aux Input, Room 2 Outputs, Video Processor Inputs and Outputs

Page 15

Video Aux Input:

This input is electrically identical to the LD input described above and will accommodate a wide variety of audio/video sources.

After selecting and connecting the source’s composite or S-Video output to the GTP-760’s corresponding “video aux” video input, connect the source’s left channel analog audio output to the white RCA jack under the “video aux in” label. Then connect the source’s right channel analog audio output to the red RCA jack under the “video aux in” label.

Room 2 Outputs:

These outputs supply video and audio signals for distribution to a secondary area or room in your home. Room 2 features are covered in section 4.3 of this manual.

Connect the composite Room 2 video output to the video display device (TV or video projector) in the remote area.

Make sure the cable(s) you use for this connection are high quality and well shielded as long cable runs act as antennas for unwanted interference signals.

d i g i t a l 2 d i g i t a l 1

L D

V C R

 

v i d e o a u x r o o m 2

i n

i n

i n

i n

o u t

i n

o u t

r o o m 2

 

 

 

 

 

o u t

v i d e o p r o c e s s o r

s t a n d a r d m o n i t o r

 

 

i n

o u t

1

2

I R r e p e a t e r

 

 

 

 

 

 

 

t a p e

 

 

 

o u t

i n

o u t

C D

f r o n t

r e a r

L

R

(Depending on the distance between the GTP-760 and the display device and, to a lesser extent, the video format you’ve chosen, you may need a video distribution amplifier to make sure the signal arrives at the display device properly. Consult your ADCOM dealer for additional information if needed.)

Connect the white “Room 2 out” jack to the left channel input of the amplifier used to power speakers in the remote area. Then connect the red “Room 2 out” jack to the amplifier’s right channel input.

Video Processor Inputs and Outputs:

These connections allow easy interface with video processors. Note that a separate video processor handles video signals only so you don’t need to concern yourself with any audio connections between it and the GTP-760. ( For additional information, consult your video processor’s manual )

v i d e o p r o c e s s o r

i n

o u t

Connect the processor’s composite video output to the GTP-760’s yellow-center “Video Processor in” jack. Then connect the video processor’s composite input to the GTP-760’s yellow-center “Video Processor out” jack.

If you are using the GTP-760 with a separate video processor, make sure you’ve set the Video Processor switch to the “ON” position.

14

Page 14 Page 16
Image 15
Page 14 Page 16
Contents GTP-760 Page Explanation of Graphic Symbols Safety NotificationConcealed Shipping Damage Adcom Protection Plan USA onlyTable of Contents Initial Setup On Screen DisplaySurround Modes Tuner Room Front Panel Controls Product FeaturesPage Center Channel and Subwoofer Rear Panel Inputs & Outputs System ConnectionsYellow centers Digital Audio inputsComposite or S-Video? DVD Digital Audio/Standard Composite Video Inputs I g g e r o u t VCR Inputs and Outputs 21 12 Volt Trigger OutputVideo Aux Input Room 2 OutputsVideo Processor Inputs and Outputs Tape Inputs and Outputs Standard Composite Video Monitor OutputsCD Inputs Video Inputs and Outputs Video Processor On/Off Switch Remote Control ConnectionsPreamplifier Outputs 27 5.1 Channel Inputs AC Power Cord Receptacle export modelsAC Convenience Outlets 115VAC models Remote Control54 55 Input Selectors tape, LD PowerVolume Up/Down Tuning Up/Down44 FM/AM Down arrow/StopSelect/Play ShiftCenter Down Rear UpRear Down Center UpMain Tuner All Others Dig.1Dig.2 Programming Your Adcom GTP-760 Remote Controller Using Preprogrammed CommandsIntroduction Programming Your Own Commands Macro Commands Deleting clearing Individual Programmed CommandsINSTALLING/CONNECTING the GTP-760 PlacementConnections What this section is all about Channel DelaysDIM L DIM C DIM R DIM LS DIM RS Preset 1 Main Small, Center On, Rears On, Subwoofer On Preset 2 Main Large, Center On, Rears On, Subwoofer OffPreset 3 Main Large, Center On, Rears On, Subwoofer On Sound Meter By EarInput Settings Basic Operation Operating Mode SelectionPage Tuner Selecting stations Programming Preset StationsOperating Room 2 From the Front Panel Listening to Preset StationsSetting Room 2 Playback Volume Room 2 Operation IntroductionOperating Room 2 From Room Trouble ShootingPage CARE, MAINTENANCE, and Service Specifications GTP-760 This page has been interntionally left blank Timber Lane Marlboro, NJ Tel 732 Fax 732

GTP-760 specifications

The Adcom GTP-760 is a high-performance audio/video surround processor that combines advanced technology with ease of use, delivering an exceptional home theater experience. At the heart of the GTP-760 is its extensive support for various audio formats, including Dolby Digital, DTS, and MPEG. This enables the processor to provide an immersive audio experience, allowing users to enjoy their favorite movies, music, and games with remarkable clarity.

One of the standout features of the GTP-760 is its multiple input options. It comes equipped with a range of analog and digital inputs, including HDMI, allowing for seamless integration with a variety of audio and video sources. The HDMI inputs support 4K video pass-through and scaling, making the GTP-760 a future-proof option for home theater setups. Additionally, the inclusion of S-Video, composite, and component video connections ensures compatibility with older devices.

The GTP-760 also offers a comprehensive equalization system, allowing users to tailor their audio output to suit their room’s acoustics and personal preferences. The built-in audio DSP (Digital Signal Processor) delivers advanced sound processing capabilities, enhancing the overall listening experience. With customizable sound modes, users can select settings optimized for music, movies, or gaming, ensuring versatility for different content types.

User friendliness is a focal point of the GTP-760 design. The intuitive front panel controls and the ergonomic remote make navigation a breeze, while the backlit display provides clear visibility, even in low light environments. Additionally, the processor features programmable memory settings, allowing users to save different configurations for quick access.

Beyond audio performance, the GTP-760 offers robust video processing capabilities. It supports various video formats, ensuring high-quality picture output regardless of the source. The unit’s solid build quality and premium components contribute to its reliability and longevity.

In conclusion, the Adcom GTP-760 is a well-rounded surround processor that delivers outstanding sound quality and video processing capabilities. Its variety of input options, advanced audio technologies, and user-friendly design make it an excellent choice for both amateur and avid home theater enthusiasts. With its ability to enhance audio-visual experiences, the GTP-760 stands out as a remarkable addition to any entertainment system.
Top Page Image Contents