Millennium Enterprises Stereo150 manual Setting up an LFO, Setting up a Dynamic Modifier

Section - 5 Advanced Topics Johnson Millennium

Setting up an LFO

To set up an LFO that is linked to an effect parameter, the procedure is as follows:

1.Enter Assign Mode by pressing the <Assign> button.

2.Use the <Page> knob to scroll to the LFO page. The display looks something like:

2	LFO						WvForm Speed
		1￿msdB%kHz			OffmsdB%kHz			SinmsdB%kHz		006 Hz
	1			2			3		4
	LINK CHANGED			LINK CHANGED			LINK CHANGED		LINK CHANGED
			WAH TUBE EQ			#	GATE
											L/R OUTS
FACTORY USER
BANK
PAGE17 OF 19 b											L/R OUTS

3.You can use the <1> knob to select which of the two LFOs you want to adjust.

4.Use the <2> knob to turn the LFO on or off.

5.Use the <3> knob to change the selected LFO's waveform. You can select SINe, TRIangle, SPecial1, SPecial2.

6.Use the <4> knob to adjust the speed of the LFO cycle.

Any parameters assigned to the LFOs will now follow the modulating waveform of the LFO you selected.

Setting up a Dynamic Modifier

1.Enter assign Mode by pressing the <Assign> button.

2.Use the <Page> knob to scroll to the first of two Dyn pages. The display looks something like:

2	Dyn						LoThrs HiThrs
		1￿msdB%kHz			OffmsdB%kHz			0 msdB%kHz		0
	1			2			3		4
	LINK CHANGED			LINK CHANGED			LINK CHANGED		LINK CHANGED
			WAH TUBE EQ			#	GATE
											L/R OUTS
FACTORY USER
BANK
PAGE 18OF 19 b											L/R OUTS

3.You can use the <1> knob to select which of the two Dyns you want to adjust.

4.Use the <2> knob to turn the Dyn on or off.

5.Use the <3> knob to set the threshold above which dynamic modification of the parameter begins.

6.Use the <4> knob to set the point at which maximum Parameter modification occurs.

7.Use the <Page> knob to scroll to the next Dyn page.

58

User Guide