JVC GR DVL 200 specifications 62 EN

62 EN		TROUBLESHOOTING (cont.)
	SYMPTOM	POSSIBLE CAUSES	CORRECTIVE ACTION
	21. White Balance cannot be	21. • The Sepia or Monotone	21. • Turn off Sepia or Monotone
	activated.	mode is activated.	before setting White
			Balance ( pg. 28, 30).
	22. When shooting a subject	22. • This is a result of exceed-	22.
	illuminated by bright light,	ingly high contrast, and is	————
	vertical lines appear.	not a malfunction.
	23. When the screen is under	23. • This is not a malfunction.	23.
	direct sunlight during
	shooting, the screen		————
	becomes red or black for
	an instant.
	24. During recording, the date/	24. •“DATE/TIME” is set to	24. • Set “DATE/TIME” to “ON”
	time does not appear.	“OFF” in the Menu Screen.	in the Menu Screen
		• Self-Recording is performed.	( pg. 25).
			• During Self-Recording, the
			date/time does not appear
			( pg. 15).
	25. Images stored in the built-	25. • Images stored in the built-in	25. • Remove protection from the
	in memory cannot be	memory are protected.	images stored in the built-in
	deleted.		memory and delete them
			( pg. 37, 38).
	26. The indicators and	26. •“ON SCREEN” is set to	26. • Set “ON SCREEN” to “LCD”
	messages do not appear.	“SIMPLE” or “TIME CODE”	or “LCD/TV” and set
		is set to “OFF” in the Menu	“TIME CODE” to “ON”
		Screen.	in the Menu Screen
			( pg. 25, 32).
	27. Images on the LCD	27. • In places subject to low	27. • Adjust the brightness and
	monitor appear dark or	temperature, images become	angle of the LCD monitor
	whitish.	dark due to the characteristics	( pg. 14, 15).
		of the LCD monitor. When
		this happens, the displayed
		colours differ from those that
		are actually recorded. This is
		not a defect of the camcorder.
		• When the LCD monitor's
		fluorescent light reaches the
		end of its service life,
		images on the LCD monitor
		become dark. Consult your
		nearest JVC dealer.
	28. The rear of the LCD	28. • The light used to illuminate	28. • Close the LCD monitor to
	monitor is hot.	the LCD monitor causes it to	turn it off or set the Power
		become hot.	Switch to “OFF”, and let the
			unit cool down.
	29. The indicators and the	29. • This may occur when the	29.
	image colour on the LCD	surface or the edge of the	————
	monitor are not clear.	LCD monitor is pressed.