JVC GR DVL 200 specifications 64 EN

64 EN		TROUBLESHOOTING (cont.)
	SYMPTOM	POSSIBLE CAUSES	CORRECTIVE ACTION
	39. The LCD monitor, the	39.	39. • Wipe them gently with soft
	viewfinder and the lens	————	cloth. Wiping strongly can
	have become dirty (ex.		cause damage ( pg. 65).
	fingerprints).
	40. An unusual mark appears.	40.	40. • Check the section of the
		————	manual that explains LCD
			monitor/viewfinder
			indications ( pg. 68 – 72).
	41. An error indication	41. • A malfunction of some kind	41. • Remove the power supply
	(E01 — E06) appears.	has occurred. In this case	(battery pack, etc.) and wait a
		the camcorder’s functions	few minutes for the indication
		become unusable.	to clear. When it does, you
			can resume using the
			camcorder.
			If the indication remains even
			though you repeat the above
			two or three times, please
			consult your nearest JVC
			dealer.
	42. The charger indicator on	42. • The temperature of the	42. • To protect the battery, it is
	the AC Power Adapter/	battery is extremely high/low.	recommended to charge it
	Charger does not light.	• Charging is difficult in	in places with a temperature
		places subject to extremely	of 10°C to 35°C ( pg. 73).
		high/low temperatures.
	43. Picture does not appear on	43. • The lens cap is attached.	43. •Remove the lens cap
	the LCD monitor.	• The LCD monitor's	( pg. 14).
		brightness setting is too	• Adjust the brightness of the
		dark.	LCD monitor ( pg. 14).
			• If the monitor is tilted
			upward 180 degrees, open
			the monitor fully ( pg. 15).
	44. When the image is printed	44. • This is not a malfunction.	44. • By recording with “DIS”
	from the printer, a black		activated ( pg. 24) this
	bar appears at the bottom		can be avoided.
	of the screen.
	45. When the camcorder is	45. • The DV cable was plugged/	45. • Turn the camcorder’s power
	connected via the DV	unplugged with power	off and on again, then
	connector, the camcorder	turned on.	operate it.
	does not operate.