JVC GR DVL 200 specifications 74 EN

Page 74

74 EN

Cassettes

To properly use and store your cassettes, be sure to read the following cautions:

1. During use . . .

.... make sure the cassette bears the Mini DV

mark.

.... be aware that recording onto prerecorded

tapes automatically erases the previously recorded video and audio signals.

.... make sure the cassette is positioned properly

when inserting.

.... do not load and unload the cassette

repeatedly without allowing the tape to run at all. This slackens the tape and can result in damage.

.... do not open the front tape cover. This exposes

the tape to fingerprints and dust.

2. Store cassettes . . .

.... away from heaters or other heat sources.

.... out of direct sunlight.

.... where they won’t be subject to unnecessary

shock or vibration.

.... where they won’t be exposed to strong

magnetic fields (such as those generated by motors, transformers or magnets).

.... vertically, in their original cases.

LCD Monitor

1. To prevent damage to the LCD monitor, DO NOT . . .

.... push it strongly or apply any shocks.

.... place the camcorder with the LCD monitor on

the bottom.

2. To prolong service life . . .

.... avoid rubbing it with coarse cloth.

3.Be aware of the following phenomena for LCD monitor use.

These are not malfunctions:

While using the camcorder, the surface around the LCD monitor and/or the back of the LCD monitor may heat up.

If you leave power on for a long time, the surface around the LCD monitor becomes hot.

CAUTIONS (cont.)

Main Unit

1. For safety, DO NOT . . .

.... open the camcorder’s chassis.

.... disassemble or modify the unit.

.... short-circuit the terminals of the battery pack.

Keep it away from metallic objects when not in use.

.... allow inflammables, water or metallic objects

to enter the unit.

.... remove the battery pack or disconnect the

power supply while the power is on.

.... leave the battery pack attached when the

camcorder is not in use.

2. Avoid using the unit . . .

.... in places subject to excessive humidity or dust.

.... in places subject to soot or steam such as near

a cooking stove.

.... in places subject to excessive shock or

vibration.

.... near a television set.

.... near appliances generating strong magnetic or

electric fields (speakers, broadcasting anten- nas, etc.).

.... in places subject to extremely high (over 40°C)

or extremely low (under 0°C) temperatures.

3.DO NOT leave the unit . . .

.... in places of over 50°C.

.... in places where humidity is extremely low (below 35%) or extremely high (above 80%).

.... in direct sunlight.

.... in a closed car in summer.

.... near a heater.

4.To protect the unit, DO NOT . . .

.... allow it to become wet.

.... drop the unit or strike it against hard objects.

.... subject it to shock or excessive vibration

during transportation.

.... keep the lens directed at extremely bright

objects for long periods.

.... expose the lens to direct sunlight.

.... carry it by holding the LCD monitor or the

viewfinder.

.... swing it excessively when using the shoulder

strap or the grip.

Image 74
Contents GR-DVL200 Dear Customer It is recommended that youEN3 Above ALLCD-ROM GR-DVL200EG Owners How To Attach The Core Filter Release the stoppers on both ends of the Core FilterLithium-ion is vulnerable in colder temperatures PowerCharging the Battery Pack About BatteriesTo Detach The Battery Pack Using the Battery PackUsing AC Power InformationShoulder Strap Attachment Grip AdjustmentViewfinder Adjustment Tripod MountingDate/Time Settings Press MENU/BRIGHT. The Menu Screen appears10 EN Loading/Unloading a CassetteEN11 Recording Mode SettingSet the tape recording mode depending on your preference Picture Quality Mode Setting 12 ENOFF Operation ModeEN13 VideoWhile recording is in progress To Adjust The Brightness Of The Display14 EN To Stop RecordingSELF-RECORDING EN15Journalistic Shooting Motor Drive Mode Power Switch Snapshot For Video RecordingSnapshot Mode Selection 16 ENImage is stored in the camcorder’s built-in memory Basic Shooting SnapshotAvailable Snapshot modes are the same as those on pg To Delete Unwanted Still ImagesZoom Slide the Power Zoom Lever towards T18 EN Zoom OutProper recording When a blank portion is recorded on a tapeEN19 20 EN Feature Video LightTo brighten the scene when natural lighting is too dim Set Light OFF/AUTO/ON as requiredEN21 Feature Auto FocusFeature Manual Focus To obtain correct focusSee pg Using Menus For Detailed AdjustmentAppears Go to stepMenu Screen Explanations EN23 Menu Screen Explanations EN25 Select OFF in step Fade/Wipe EffectsTo Deactivate The Selected Effect If you select Picture Wipe/Dissolve during recordingEN27 Fader And Wipe MenuTo Deactivate The Selected Mode Programme AE With Special EffectsEN29 Exposure ControlIris Lock To Return To Automatic White Balance White Balance AdjustmentManual White Balance Operation To Change The Tint For RecordingEN31 To Control The Speaker VolumeAvailable only with the remote control provided  pg Playback Zoom and Playback Special EffectsUsing Menus For Detailed Adjustment EN33 Playback SoundDisplay 34 EN Normal PlaybackEN35 Index ScreenIndex Playback After , press 4/6. To stop the Slide Show, press 36 ENSlide Show To Protect AN Image Protecting ImagesEN37 To Remove Protection38 EN To Delete ALL ImagesYou can initialise the camcorder’s built-in memory anytime Initialising The Built-in MemoryEN39 40 EN If using a VCR . . . go to step If not . . . go to step EN4142 EN Connection To a Personal ComputerMake sure all units are turned off Connection To a Video Unit Equipped With a DV ConnectorEN43 VCR Recording deck 44 ENDubbing To a VCR EN45 Memory To a Tape Indicator disappears when dubbing is complete46 EN Dubbing Images Recorded On a Tape To The Built-in Memory EN47Installing The Batteries 48 ENEN49 FF ButtonFeature Playback Zoom Feature Slow-Motion PlaybackFeature Frame-By-Frame Playback 50 ENFeature Playback Special Effects EN51Random Assemble Editing R.A.Edit VCR Code List52 EN SET REMOTE/VCR CodeMake Connections JVC VCR equipped with a remote pause connectorEN53 VCR other than above54 EN Select ScenesEN55 Automatic Editing to VCRDiagnosing VCR/CAMCORDER Timing 56 ENFor More Accurate Editing Recording deckAdjustment of VCR/CAMCORDER Timing EN57Audio Dubbing Set 12BIT Mode to Sound 2 or MIX Menu Screen  pg58 EN To hear the dubbed sound during playbackBright Clean the lens and checkCorrective Action Dark place, or the contrast Focus again  pg Was lowTroubleshooting 60 ENEN61 62 EN Blink Or channel appropriate Video mode For video playbackEN63 64 EN Turn off the camcorder After Use Cleaning The CamcorderPress Battery Release and remove the battery pack Press Push Here to close the cassette holder66 EN 345 6 7 # $ %EN67 68 EN EN69 Appears when Digital Image Stabiliser DIS is engagedAutomatically adjusted Approximate zoom ratio Appears during ZoomingLCD Monitor/Viewfinder Indications During D.S.C. Playback 1Displays the sound modeLCD Monitor/Viewfinder Indications During Video Playback 5Displays the time codeEN71 FunctionUnit in Safeguard DUB ErrorCheck TAPE’S Erase Protection Switch Mode RemoveTo avoid hazards To prevent damage and prolong service lifeEN73 74 EN Serious malfunctioning EN75About moisture condensation Icons  pg 76 ENDate/Time Display  pg , 32 LCD monitor/Viewfinder  pg IndicationsEN77 Time Code  pg , 25, 32For Digital Video Camera 78 ENFor General For Digital Still CameraFor Connectors EN79GR-DVL200