JVC GR-DF473, GR-DF573 Power, How To Attach The Core Filter, Charging The Battery Pack

Connect the AC Adapter to the camcorder.

		GETTING STARTED	EN 13
How To Attach The Core Filter
		Power
Attach the core filters to the cables. The core
	This camcorder’s 2-way power supply system
filter reduces interference.
	lets you choose the most appropriate source of
1 Release the stoppers on both ends of the
	power. Do not use provided power supply units
core filter.	with other equipment.
	Charging The Battery Pack

Stopper

2 Run the cable through the core filter, leaving approx. 3 cm of cable between the cable plug and the core filter.

Wind the cable once around the outside of the core filter as shown in the illustration.

Core filter

3 cm

Wind once.

3 Close the core filter until it clicks shut.

NOTES:

●Take care not to damage the cable.

●When connecting a cable, attach the end with the core filter to the camcorder.

BATT. RELEASE

	Open the
	cover.
Battery pack		STARTED
	To
	DC connector
Arrow		GETTING
Battery pack mount	mark

Power switch

POWER/CHARGE lamp

To AC outlet

AC Adapter

(ex. AP-V17E)

1 Set the Power Switch to “OFF”.

2 With the arrow on the battery pack pointing right, push the battery pack slightly against the battery pack mount a.

3 Slide the battery pack to the right until it locks in place b.

4

5 Connect the Power Cord to the AC Adapter. (AP-V14E/A only)

6 Plug the AC Adapter into an AC outlet. The POWER/CHARGE lamp on the camcorder blinks to indicate charging has started.

7 When the POWER/CHARGE lamp goes out, charging is finished. Unplug the AC Adapter from the AC outlet. Disconnect the AC Adapter from the camcorder.

CONTINUED ON NEXT PAGE