JVC GR-DVL822U specifications Menu Screen Explanations, 10X, 40X, 700X, Factory-preset

				EN 45
Menu Screen Explanations
	WIPE/FADER		Refer to “Fade/Wipe Effects” ( pg. 38, 39).
	PROGRAM AE		Refer to “Program AE With Special Effects” ( pg. 36, 37).
	EXPOSURE		Refer to “Exposure Control” and “Iris Lock” ( pg. 42).
	W.BALANCE		Refer to “White Balance Adjustment” and “Manual White Balance Operation”
			( pg. 43).
	REC MODE		Allows you to set the tape recording mode (SP or LP) depending on your
			preference ( pg. 13).
	SOUND	12BIT	Enables tape recording of stereo sound on four separate channels, and is
	MODE		recommended for use when performing audio dubbing. (Equivalent to the
			32 kHz mode of previous models)
		16BIT	Enables tape recording of stereo sound on two separate channels. (Equivalent
			to the 48 kHz mode of previous models)
	ZOOM	10X	When set to “10X” while using digital zoom, the zoom magnification will reset
			to 10X since digital zoom will be disengaged.
CAMERA		40X	Allows you to use the Digital Zoom. By digitally processing and magnifying
			images, zooming is possible from 10X (the optical zoom limit), to a maximum
			of 40X digital magnification.
		700X	Allows you to use the Digital Zoom. By digitally processing and magnifying
			images, zooming is possible from 10X (the optical zoom limit), to a maximum
			of 700X digital magnification.
	SNAP MODE		Refer to “Snapshot (For Tape Recording)” ( pg. 40).
	GAIN UP	OFF	Allows you to shoot dark scenes with no picture brightness adjustment.
		AGC	The overall appearance may be grainy, but the image is bright.
		AUTO	The shutter speed is automatically adjusted (1/30 — 1/200 sec.). Shooting a
			subject in low or poor lighting at 1/30 sec. shutter speed provides a brighter
			image than in the AGC mode, but the subject’s movements are not smooth or
			natural. The overall appearance may be grainy. While the shutter speed is
			being automatically adjusted, “	” is displayed.
	DIS	OFF	To compensate for unstable images caused by camera-shake, particularly at
			high magnification.
MANUAL			NOTES:
		ON	● Accurate stabilization may not be possible if hand shake is excessive, or
			• When shooting dark or dim subjects.
			under the following conditions:
			• When shooting subjects with vertical or horizontal stripes.

•When shooting subjects with excessive backlighting.

•When shooting scenes with movement in various directions.

•When shooting scenes with low-contrast backgrounds.

●Switch off this mode when recording with the camcorder on a tripod.

●The “ ” indicator blinks or goes out if the Stabilizer cannot be used.

: Factory-preset

NOTES:

●Settings made in the “ CAMERA” Menu remain effective whether the Power Switch is set to “

However, the menu settings can be changed only when the Power Switch is set to “			MANUAL		”.
● The “	MANUAL” settings are effective only when the Power Switch is set to “	MANUAL		”.

AUTO

” or “

MANUAL

”.

CONTINUED ON NEXT PAGE