DETAILS | EN 65 |
I T E M S
➪Power
( pg. 8)
N O T E S
❍Perform charging where the temperature is between 10°C and 35°C (50°F and 95°F). 20°C to 25°C (68°F to 77°F) is the ideal temperature range for charging. If the environment is too cold, charging may be incomplete.
❍Charging times are for a fully discharged battery pack.
❍Charging time varies according to the ambient temperature and the status of the battery pack.
❍To avoid interference with reception, do not use the AC Adapter near a radio.
❍Since the AC Adapter processes electricity internally, it becomes warm during use. Be sure to use it only in
❍The following operation stops charging:
•Set the Power Switch to “PLAY”, “ AUTO ” or “ MANUAL ”.
•Disconnect the AC adapter from the camcorder.
•Unplug the AC adapter from the AC outlet.
•Detach the battery from the camcorder.
➪TAPE RECORDING ( pg. 16, 17)
❍When you use the LCD monitor outdoors in direct sunlight, the LCD monitor may be difficult to see. If this happens, use the viewfinder instead.
❍The cassette holder cannot be opened unless a power supply is attached.
❍There may be a delay after you open the cassette holder cover until the cassette holder opens. Do not use force.
❍Once the cassette holder is closed, it recedes automatically. Wait until it recedes completely before closing the cassette holder cover.
❍When the Recording Start/Stop button is pressed, it may take a few seconds before actual recording starts. “ 
” starts rotating when the camcorder actually starts recording.
❍The time required to calculate and display the remaining tape length, and the accuracy of the calculation, may vary according to the type of tape used.
❍“TAPE END” appears when the tape reaches its end, and the power goes off automatically if left in this condition for 5 minutes. “TAPE END” also appears when a cassette at its end is loaded.