JVC GR-DVL822U specifications 82 EN

82 EN	INDEX Indications (cont.)
Indications	Function
INSERT ERROR!	Appears if Insert Editing is attempted on a blank portion of a tape.	( pg. 62)
INSERT ERROR!	● Appears if Insert Editing is attempted on a tape recorded in the LP mode.
<CANNOT EDIT		( pg. 62)
ON A LP RECORDED TAPE>	● Appears if INSERT (w) on the remote control is pressed when the erase
<CHECK TAPE’S ERASE	protection tab is set to “SAVE”.	( pg. 62)
PROTECTION TAB>
MEMORY IS FULL	Appears when the memory card’s memory is full and shooting is not
	possible.
	● Appears if dubbing of copyguarded signals is attempted while this
	camcorder is being used as a recorder.
COPYING FAILED	● Appears in the following cases when dubbing from a tape to a memory
	card:
	– when no memory card is loaded.
	– when the memory card's memory is full.	( pg. 52)
	– when the memory card is not formatted.
MEMORY CARD!	Appears if there is no memory card loaded when you attempt to record on a
or	memory card or access data on a memory card.
PLEASE INSERT CARD
PLEASE	Appears when there is a problem with a memory card and its memory is
FORMAT	corrupt, or it has not been initialized. Initialize the memory card.	( pg. 34)
NO IMAGES STORED	Appears if there are no image files stored on the memory card when you
	attempt memory card playback.
	Appears when the camcorder does not recognize the loaded memory card.
CARD ERROR!	Remove the memory card once and insert it again. Repeat these procedures
	until no indication appears. If the indication still appears, the memory card is
	corrupted.
UNSUPPORTED FILES	Appears if a file in another format is selected.
CHECK CARD’S WRITE	● Appears when you attempt to record on a copy-protected SD Memory Card.
	● Appears when you attempt Memory Card menu operation with a copy-
PROTECTION SWITCH
	protected SD Memory Card loaded.
E01, E02 or E06	The error indications (E01, E02 or E06) show what type of malfunction has
	occured. When an error indication appears, the camcorder turns off automati-
UNIT IN SAFEGUARD
	cally. Remove the power supply (battery, etc.) and wait a few minutes for the
MODE REMOVE AND
	indication to clear. When it does, you can resume using the camcorder. If the
REATTACH BATTERY
	indication remains, consult your nearest JVC dealer.
E03 or E04	The error indications (E03 or E04) show what type of malfunction has
	occured. When an error indication appears, the camcorder turns off
UNIT IN SAFEGUARD
	automatically. Eject the cassette once and re-insert it, then check if the
MODE EJECT AND
	indication clears. When it does, you can resume using the camcorder. If the
REINSERT TAPE
	indication remains, consult your nearest JVC dealer.