32 EN FEATURES FOR RECORDING
5-Second Recording
Record a vacation or an important event in
1 Set “5S” to “5S”. ( pg. 28)
●The “5S” indicator appears.
2 Press the Recording Start/Stop Button to start recording, and after 5 seconds the camcorder enters
●Even if you press the Recording Start/Stop Button again within 5 seconds after recording starts,
3 To exit the 5S mode, select “OFF” in step 1.
To take a snapshot in the 5-second recording mode
Instead of pressing the Recording Start/Stop Button in step 2, select the desired Snapshot mode in CAMERA Menu ( pg. 28), then press SNAPSHOT. The camcorder records a
NOTE:
When “5S” is set to “Anim.”, the
Night-Scope
Makes dark subjects or areas even brighter than they would be under good natural lighting. Although the recorded image is not grainy, it may look as if it is strobing due to the slow shutter speed.
1 Set the Power Switch to “M”.
2 Press NIGHT so that the 
” appears.
●The shutter speed is automatically adjusted to provide up to 30 times sensitivity.
●“
” appears beside “
” while the shutter speed is being automatically adjusted.
To deactivate Night-Scope
Press NIGHT again so that the
NOTES:
●During
•Some modes of “Program AE With Special Effects” ( pg. 35).
•“GAIN UP” in CAMERA Menu. ( pg. 28)
•“DIS” in MANUAL Menu. ( pg. 28)
●During
Snapshot (For Video Recording)
This feature lets you record still images that look like photographs onto a tape.
1 Set the VIDEO/MEMORY Switch to “VIDEO”.
2 Set the Power Switch to “M”.
3 Set “SNAP MODE” to the desired mode. ( pg. 27, 28)
4 Press SNAPSHOT.
●There is the sound effect of a shutter closing.
●The “O” indication appears and a still image will be recorded for approx. 6 seconds, then the camcorder re- enters the
●You can perform Snapshot also during recording. A still image will be recorded for approx. 6 seconds, then the normal recording resumes.
●Regardless of the Power Switch position (“A” or “M”), Snapshot recording takes place using the selected Snapshot mode.
Motor Drive Mode
Keeping SNAPSHOT pressed in step 4 provides an effect similar to serial photography. (Interval between still images: approx. 1 second)
●The Motor Drive mode is disabled when “REC SELECT” is
set to “
/
”. ( pg. 30)
Manual Focus
The camcorder’s Full Range AF system offers continuous shooting ability from
However, correct focus may not be obtained depending on the shooting condition. In this case, use the manual focus mode.
1 Set the Power Switch to “M”.
2 Press FOCUS. The manual
focus indicator appears.
3 Press 
or 
to focus on a subject.
● When the focus level cannot be
adjusted any further or closer, Manual focus indicator “ ” or “ 
” will blink.
4 Press SET. Focus adjustment is complete.
To reset to Auto Focus
Press FOCUS twice or set the Power Switch to “A”.
Manual focus is recommended in situations listed below.
●When two subjects overlap in the same scene.
●When illumination is low.*
●When the subject has no contrast (difference in brightness and darkness), such as a flat,
●When a dark object is barely visible in the LCD monitor or the viewfinder.*
●When the scene contains minute patterns or identical patterns that are regularly repeated.
●When the scene is affected by sunbeams or light reflecting off the surface of a body of water.
●When shooting a scene with a 
,
, 
and 
.