JVC GR-DX317, GR-DX107, GR-DX307 Dubbing, EN Editing, Any image or sound deterioration, Manual

Set the camcorder’s Power Switch to “PLAY”.

38 EN EDITING

	Dubbing To Or From A Video Unit	To use this camcorder as a player
		1 Make sure all units are turned off.
	Equipped With A DV Connector (Digital
		2 Connect this camcorder to a video unit equipped with
	Dubbing)	a DV input connector using a DV cable as shown in the
		illustration.
It is also possible to copy recorded scenes from the		3 Start playback on the camcorder. ( pg. 17)
camcorder onto another video unit equipped with a DV		4 At the point you want to start dubbing, start recording
connector. Since a digital signal is sent, there is little if
		on the video unit. (Refer to the video unit’s instruction
any image or sound deterioration.
		manual.)
		5 To stop dubbing, stop recording on the video unit, then
		stop playback on this camcorder.
		NOTES:

Core filter

To DV IN/OUT

DV cable (optional)

●It is recommended to use the AC Adapter as the power supply instead of the battery pack. (
pg. 11)

●If a blank portion or disturbed image is played back on the player during dubbing, the dubbing may stop so that an unusual image is not dubbed.

●Even though the DV cable is connected correctly, sometimes the image may not appear in step 4. If this occurs, turn off the power and make connections again.

●If “Playback Zoom” (
pg. 20) or “Playback Special Effects” (
pg. 20) is attempted or SNAPSHOT is pressed during playback, only the original playback image recorded on the tape is output from the DV IN/OUT connector.

●When using a DV cable, be sure to use the optional JVC VC-VDV204U DV cable.

To use this camcorder as a recorder

1 Make sure all units are turned off.

2 Connect this camcorder to a video unit equipped with a DV output connector using a DV cable as shown in the illustration.

To DV IN/OUT

Video unit equipped with DV connector

3 Set “REC MODE” to “SP” or “LP”. (
pg. 27, 28)

4

5 Press the Recording Start/Stop Button to engage the Record-Pause mode.

●The “ DV. IN ” indication appears on the screen.

6 Start playback on the player.

7 At the point you want to start dubbing, press the Recording Start/Stop Button to start dubbing. The indication rotates.

8 Press the Recording Start/Stop Button again to stop

dubbing. The indication stops rotating.

9 Press 8 to return to the normal playback mode.

NOTES:

●If no image is displayed on the LCD monitor, set “S/AV INPUT” to “OFF”. (
pg. 27, 30)

●Digital Dubbing is performed in the sound mode recorded on the original tape, regardless of the current “SOUND MODE” setting. (
pg. 28)