JVC GR-DVF20, LYT0244-001A manual 30 EN, Picture Wipe or Dissolve Selection P, P, P, P , P, P and P

30EN

RECORDING

AdvancedFeatures(cont.)

Recording Start/Stop Button

Previous scene end

[Ex.: P WIPE – SCROLL]

Within 5 minutes . . .

Wipe-in

PICTURE WIPE OR DISSOLVE SELECTION (P, P, P, P , P, P and P )

Combine the Picture Wipe and Dissolve functions for a professional transition effect. There are 6 Picture Wipe effects and 1 Dissolve effect. The Picture Wipe or Dissolve works when recording is started.

Before the following steps, perform steps 1 through 3 on pg. 29.

4 STORE SCENE IN MEMORY Engage the Record-Standby mode.

If you select Picture Wipe/Dissolve during recording . . .

.... press the Recording Start/Stop Button when one

scene is finished. The point at which the scene ended is stored in memory.

If you select Picture Wipe/Dissolve during Record- Standby mode . . .

.... press the Recording Start/Stop Button to start

recording and press it again when one scene is finished. The point at which the scene ended is stored in memory.

If you select Picture Wipe/Dissolve during Record- Standby mode after performing a Picture Wipe/ Dissolve . . .

.... the point at which the scene ended is already

stored in memory.

5 START RECORDING

If you start recording a new scene within 5 minutes of the end of the previous recording (without having turned the camcorder’s power off), the previous scene wipes out, revealing the new scene.

NOTES:

●You can extend the length of a Fade or Wipe by pressing and holding the Recording Start/Stop Button.

●If the power is turned off after a scene is finished recording, the stored point is erased.

This disables the Picture Wipe/Dissolve combination. When this happens, the Picture Wipe/Dissolve indicator blinks. Try recording again, but do not turn the power off when you are finished. Please be advised that power also shuts off automatically if 5 minutes elapse in the Record-Standby mode.

●The sound at the end of the last recorded scene is not stored.