JVC GR-DVF20, LYT0244-001A manual Date/Time Menu Explanations, System Menu Explanations

28ENRECORDING

AdvancedFeatures(cont.)

Date/Time Menu Explanations

ON SCREEN	OFF	Keeps the camcorder's display from appearing on the connected TV
		screen.
	ON	Makes the camcorder's display appear on screen when the camcorder
		is connected to a TV.
DISPLAY	ON	Makes the date/time settings appear in the camcorder (☞ pg. 11).
	OFF	Keeps the date/time settings from appearing in the camcorder.
DATE/TIME	Allows you to set the current date and time (☞ pg. 11).
System Menu Explanations
PHOTO MODE	Allows you to set the parameters for “FULL”, “FRAME”, “PIN-UP”, “MULTI 4” and
	“MULTI 9” recording (☞ pg. 24).
TALLY	ON	The tally lamp comes on to signal the start of recording.
	OFF	The tally lamp remains off at all times.
WIND CUT	OFF	Disengages the function which cuts down on noise created by wind.
	ON	Helps cut down on noise created by wind.
		•“ ” appears.
		•The quality of the sound will change. This is normal.
SOUND MODE	32 kHz	Enables recording of stereo sound on four separate channels, and is
		recommended for use when performing audio dubbing with another
		digital camcorder.
	48 kHz	Enables recording of stereo sound on two separate channels.
ID NUMBER	This number is necessary when connecting the camcorder to a device such as a
	computer using the J terminal (JLIP). The numbers range from 01 to 99. Factory setting
	is 06.
DEMO. MODE	OFF	Automatic demonstration will not take place.
	ON	Demonstrates certain functions such as Program AE with special
		effects, etc., and can be used to confirm how these functions operate.
		When “DEMO. MODE” is set to “ON” and the Recording Menu is
		closed, demonstration starts.

NOTES:

●If a tape is in the camcorder, the demonstration cannot be turned on.

●By turning off the camcorder, “DEMO. MODE” is set to “OFF” automatically.

: Factory-preset