JVC GRDVM80U, GR-DVM80 specifications Menu Screen Explanations EN25

Menu Screen Explanations				EN25
	FADER/WIPE		Refer to “Fade/Wipe Effects” ( pg. 30, 31).
	P.AE/EFFECT		Refer to “Program AE With Special Effects” ( pg. 32, 33).
	W.BALANCE		Refer to “White Balance Adjustment” and “Manual White Balance Operation”
			( pg. 35).
	REC MODE		Allows you to set the recording mode (SP or LP) depending on your
			preference ( pg. 13).
	SOUND	12 BIT	Enables recording of stereo sound on four separate channels, and is recom-
	MODE		mended for use when performing audio dubbing. (Equivalent to the 32 kHz
			mode of previous models)
		16 BIT	Enables recording of stereo sound on two separate channels. (Equivalent to the
			48 kHz mode of previous models)
	ZOOM	10X	When set to “10X” while using digital zoom, the zoom magnification will
			reset to 10X since digital zoom will be disengaged.
		40X	Allows you to use the Digital Zoom. By digitally processing and magnifying
			images, zooming is possible from 10X (the optical zoom limit), to a maximum
			of 40X digital magnification.
		200X	Allows you to use the Digital Zoom. By digitally processing and magnifying
			images, zooming is possible from 10X (the optical zoom limit), to a maximum
MENU			of 200X digital magnification.
	SNAP	FULL	Refer to “Snapshot” ( pg. 18).
CAMERA	MODE
		PIN-UP
	GAIN UP	OFF	Allows you to shoot dark scenes with no picture brightness adjustment.
		AGC	The overall appearance may be grainy, but the image is bright.
		AUTO	The shutter speed is automatically adjusted (1/30 — 1/200 sec.). Shooting a
			subject in low or poor lighting at 1/30 sec. shutter speed provides a brighter
			image than in the AGC mode, but the subject’s movements are not smooth or
			natural. The overall appearance may be grainy. When shooting a subject in
			low lighting in this mode, “	” is displayed.
	BEEP/	ON: MEL.	The tally lamp comes on to signal the start of recording. Instead of a beep, a
	TALLY		melody sounds when any operation is performed. It also activates the shutter
			sound effect ( pg. 18).
		ON:BEEP	The tally lamp comes on to signal the start of recording.
			The beep sounds when the power is turned on or off, and at the beginning and end
			of recording. Also to activate the shutter sound effect ( pg. 18).
		OFF	The tally lamp remains off at all times.
			Even though not heard while shooting, shutter sound is recorded on the tape.
	ID	This number is necessary when connecting the camcorder to a device such as a computer
	NUMBER	using the J terminal (JLIP). The numbers range from 01 to 99. Factory setting is 06.

NOTE:

The “ CAMERA MENU” settings are effective when the Operation Switch is set to both “ ” and “ ”.

: Factory-preset

CONTINUED ON NEXT PAGE