62 EN | TROUBLESHOOTING (cont.) |
SYMPTOM |
| POSSIBLE CAUSES |
|
35. The LCD monitor image is |
| 35. • During playback of the |
|
distorted. |
| unrecorded portion, |
|
|
| Search and still playback, LCD |
|
|
| monitor indications appear |
|
|
| distorted. This is not a defect. |
|
36.Images on the LCD monitor 36. • The speaker volume is too great. are jittery.
37. | Blocks of noise appear | 37. |
| during playback, or there is | |
| no playback picture and the | |
|
| |
| screen becomes blue. |
|
|
|
|
38. | The LCD monitor, the | 38. |
| viewfinder and the lens have | |
| become dirty (ex. fingerprints). |
|
|
|
|
39. | An unusual mark appears. | 39. |
|
| |
|
|
|
40. | An error indication | 40. • A malfunction of some kind |
| (E01 — E06) appears. | has occurred. In this case the |
|
| camcorder’s functions |
|
| become unusable. |
41.The charger indicator on the 41. • The temperature of the battery
| AC Power Adapter/Charger |
| is extremely high/low. |
| does not light. |
| • Charging is difficult in places |
|
|
| subject to extremely high/low |
|
|
| temperatures. |
|
|
|
|
42. | Picture does not appear on | 42. | • The viewfinder is pulled out. |
| the LCD monitor. |
| • The LCD monitor's brightness |
|
|
| setting is too dark. |
|
|
|
|
43. | When the image is printed | 43. | • This is not a malfunction. |
| from the printer, a black bar |
|
|
| appears at the bottom of the |
|
|
| screen. |
|
|
|
|
|
|
44. | When the camcorder is | 44. | • The DV cable was plugged/ |
| connected via the DV |
| unplugged with power turned |
| connector, the camcorder |
| on. |
| does not operate. |
|
|
|
|
|
|
45. | During transport, the lens | 45. |
|
| cover opens. |
| |
|
|
|
CORRECTIVE ACTION
35.
36.• Turn the speaker volume down ( pg. 36).
37.•Clean the video heads with an
optional cleaning cassette ( pg. 70).
38.• Wipe them gently with soft
cloth. Wiping strongly can cause damage ( pg. 57).
39.• Check the section of the manual that explains LCD
monitor/viewfinder indica- tions ( pg. 66 – 68).
40.• Remove the power supply (battery pack, etc.) and wait a few minutes for the indication to clear. When it does, you can resume using the camcorder. If the indication remains even though you repeat the above two or three times, please consult your nearest JVC dealer.
41.• To protect the battery, it is recommended to charge it in places with a temperature of
10°C to 35°C (50°F to 95°F) ( pg. 69).
42.• Push the viewfinder back in.
•Adjust the brightness of the LCD monitor ( pg. 16).
•If the monitor is tilted upward
180 degrees, open the monitor fully ( pg. 16).
43.• By recording with “DIS” activated ( pg. 26) this can be avoided.
44.• Turn the camcorder’s power off
and on again, then operate it.
45.• Do not subject the camcorder to shock or excessive vibration during transport.
•Turn the camcorder on and off. The lens cover closes.