JVC GR-DVM80, GRDVM80U specifications 68 EN, Indications Function

68 EN INDEX Indications (cont.)

Warning Indications

Indications			Function
	Displays the battery remaining power.
	Remaining power level: high
	Remaining power level: exhausted
	As the battery power comes close to nil, the battery indicator				blinks.
	When the battery power is exhausted, power turns off automatically.
	Appears when no tape is loaded.			( pg. 12)
CHECK TAPE’S ERASE	Appears when the erase protection tab is set to “SAVE” while the POWER
PROTECTION SWITCH	Switch is set to “	”.		( pg. 12)
	Appears if dirt is detected on the heads during recording. Use an optional
HEAD CLEANING	cleaning cassette.			( pg. 70)
REQUIRED USE
CLEANING CASSETTE
	Appears if condensation occurs. When this indication is displayed, wait
	more than 1 hour until condensation disappears.
CONDENSATION
OPERATION PAUSED
PLEASE WAIT
	Appears if a tape is not loaded when START/STOP is pressed while the
TAPE!	POWER Switch is set to “		” and the MODE Dial is set to “VIDEO”
	or “ ”.
TAPE END	Appears when the tape ends during recording or playback.			( pg. 17)
DIFFERENT	Appears if a tape in another format is loaded.
FORMATTED TAPE
	● Appears when the date/time is not set.			( pg. 11)
SET DATE/TIME!	● Appears when the built-in clock (lithium) battery is discharged and the
	previously set date/time is erased.			( pg. 11)
A. DUB ERROR!	Appears if Audio Dubbing is attempted on a blank portion of a tape.
				( pg. 56)
A. DUB ERROR!	● Appears if Audio Dubbing is attempted on a tape recorded in the LP
	mode.			( pg. 56)
<CANNOT DUB
ON A LP RECORDED	● Appears if Audio Dubbing is attempted on a tape recorded in 16-bit
TAPE>	audio.			( pg. 56)
<CANNOT DUB	● Appears if A. DUB (e) on the remote control is pressed when the erase
ON A 16BIT	protection tab is set to “SAVE”.			( pg. 56)
RECORDING>
<CHECK TAPE’S ERASE
PROTECTION SWITCH >
E01 — E06	The error indications (E01 — E06) show what type of malfunction has
	occured. When an error indication appears, the camcorder turns off
UNIT IN SAFEGUARD
	automatically. Remove the power supply (battery, etc.) and wait a few
MODE REMOVE AND
	minutes for the indication to clear. When it does, you can resume using the
REATTACH BATTERY
	camcorder. If the indication remains, consult your nearest JVC dealer.