POWER Switch
Lock Button
Open the connector cover.
To DV IN/OUT |
|
| Core filter |
| DV cable |
| (optional) |
| Core filter |
To DV IN/OUT | Video unit equipped |
| |
| with DV connector |
PLAY (4)
STOP (5)
EN45
Dubbing To Or From A Video Unit Equipped With A DV Connector (Digital Dubbing)
It is also possible to copy recorded scenes from the camcorder onto another video unit equipped with a DV connector. Since a digital signal is sent, there is little if any image or sound deterioration.
[To use this camcorder as a player]
1 Make sure the camcorder’s power is off.
2 Connect the camcorder to your video unit equipped with a DV connector using a DV cable as shown in the illustration.
3 Press 4to play back the source tape.
4 While watching the playback on the monitor, engage the DV
NOTES:
●It is recommended to use the AC Power Adapter/
Charger as the power supply instead of the battery pack ( pg. 9).
●If the remote control is used when both the player and recorder are JVC video units, both units will perform the same operation. To prevent this from happening, press the buttons on both units.
●For Digital Dubbing, this camcorder can be connected only to one device at a time. This camcorder can also be used as a recorder.
●If a blank portion or disturbed image is played back on the player during dubbing, the dubbing may stop so that an unusual image is not dubbed.
●Even though the DV cable is connected correctly, sometimes the image may not appear in step 3. If this occurs, turn off the power and make connections again.
●If “Playback Zoom” ( pg. 48), “Playback Special Effects” ( pg. 49) or “Snapshot” is attempted during playback, only the original playback image recorded on the tape is output from the DV IN/OUT connector.
●When using a DV cable, be sure it has a core filter attached. The core filter reduces interference.
To Use This Camcorder As A Recorder . . .
1.Turn the POWER Switch to “ PLAY/PC ” while pressing down the Lock Button located on the switch.
2.Set “REC MODE” to “SP” or “LP” in the Menu Screen ( pg. 37)
3.Connect the DV cable as shown in the illustration and load a cassette to record on.
4.Press START/STOP to engage the
5.Press START/STOP to start recording. “DV IN” changes to “ DV IN ”.
6.Press START/STOP again to engage the
NOTES:
●Digital Dubbing is performed in the sound mode recorded on the original tape, regardless of the current “SOUND MODE” setting ( pg. 25).
●During Digital Dubbing, no signals are output from the AV OUT connector.