JVC LYT0002-088B manual END SET Menu Button, Sound signals can be sampled at 32 kHz or 48 kHz

EN 33

						5S
	SCENE		5	S		5SD
						ANIM.		ON
	BEEP/TALLY		ON					OFF
	W IND CUT		OFF					OFF
	SOUND	MODE	32kHz				32 kHz	AUTO
	I D No .		06				48 kHz
	PHOTO FRAME		ON				This number is necessary when
						ON	connecting the camcorder to a
		I TEM	–/+ BUTTON			OFF	computer [01 to 99].
	END	SET	MENU BUTTON
SCENE (5-Second Mode) (☞ pg. 28)					WIND CUT

5S–PressingRECORDING START/STOP allows you to take a 5-second “clip”. Press repeatedly for a succession of short recordings.

5SD–If you record a 5-second clip within 5 minutes after the previous one, the end of the old scene dissolves and is replaced by the new scene over a 2-second period.

ANIM. (Animation)–Each time you press RECORDING START/STOP, a 1/8-second recording is taken. By using an inanimate object and changing its position between shots, you can record the subject as though it’s moving.

Animation is not available in the LP mode. If you tried to record in the LP mode after setting ANIM., the recording mode indicator "LP" begins to blink, and recording goes on in the SP mode.

NOTE:

During use of SCENE effect, focus (☞ pg. 46) and exposure control (☞ pg. 47) enter Full Auto operation.

BEEP/TALLY

The beep sounds when the power is turned on or off, and at the beginning and end of recording. Tally lamp lights up during recording.

Shutter sound is heard when pressing the SNAP- SHOT button.

ON–To activate the beep/shutter sounds and tally lamp.

OFF–To turn off the beep/shutter sounds and tally lamp. Even though not heard while shooting, shutter sound is recorded on the tape.

NOTE:

Beep is automatically turned on during Full Auto operation.

When activated, this mode helps cut down on noise created by wind.

AUTO–When shooting in high winds, noise is automatically reduced.

•“” appears in the LCD monitor.

•The quality of the sound will change. This is normal.

OFF–This function is disabled.

NOTE:

The Wind Cut mode is disabled during Full Auto operation.

SOUND

Sound signals can be sampled at 32 kHz or 48 kHz.

32 kHz–The camcorder is factory-preset for 32 kHz. This setting enables recording of stereo sound on four separate channels, and is recommended for use when performing Audio Dubbing.

48 kHz– This setting enables recording of stereo sound on two separate channels. *A tape recorded at 48 kHz cannot be used for Audio Dubbing.

PHOTO FRAME

The snapshot function (☞ pg. 26) has two types of photo effects; with frame and without frame.

ON–When engaged during recording, there will be a momentary camera shutter-type blackout, a shutter sound effect is recorded on the tape, and a white-bordered still image is displayed and recorded.

OFF–When engaged during recording, a still image is displayed and recorded.

NOTE:

Photo Frame can not be set to OFF during Full Auto operation.