JVC LYT0002-088B manual Connect Docking Station to TV or VCR, Turn on Power Select TV’S Video Mode

3	AC Power Adapter/Charger
To DC	To DC
input jack
	output jack
	DC cord

EN 53

Connection to an S-VHS recorder or a TV with an S-Video connector (4-pin)

Core filter

Core filter

To S-VIDEO	S-VIDEO cable
	To S-VIDEO input jack
output jack
To AUDIO input jacks (L/R)		Red
To AUDIO		White
output jacks (L/R)		Yellow

To VIDEO input jack

Red

AUDIO/VIDEO cables

White

Core filter Yellow

To VIDEO output jack

Connect to AV jack-equipped TV or to VCR

VCR

(Recording deck)

1 CONNECT DOCKING STATION TO TV OR VCR

Connect as shown in the illustration (☞ pg. 52, 53).

2 TURN ON POWER

3 SELECT TV’S VIDEO MODE

Set the TV to the channel or mode appropriate for video playback.

If Using A VCR . . . go to step 4.

If not . . . go to step 5.

4 CONNECTINPUT VCR OUTPUT TO TV

Refer to your VCR’s instruction manual.

5 START PLAYBACK

Press play and your pre-recorded scenes will be played on your TV.

6 END PLAYBACK

Press STOP and, if you’re not going to continue using the camcorder, set the Power Dial to “OFF”.

NOTES:

●To change from normal to slow-motion playback, press PAUSE at the point where you want to start playback in slow motion, then point the remote control at the Docking Station's sensor and press SLOW (Rewind/Forward). After playing back in slow motion for about 10 to 20 seconds, normal playback resumes. Speed is 1/10 times normal. To stop slow-motion playback in progress, press PLAY.

●During slow-motion playback, due to digital image processing, the picture may take on a mosaic effect.

●After SLOW is pressed, the still image may be displayed for a few seconds, then the screen may become blue back for a few seconds.

●There may be a small margin between the slow- motion playback start point you chose and the start point at which the camcorder actually begins playback in slow motion.

●When using the provided AUDIO/VIDEO cable (Docking Station to TV or VCR), DC cord, S-VIDEO cable or editing cable, make sure you connect the end of the cable with the core filter to the Docking Station. The core filter improves performance of equipment.

●Set the VIDEO OUT select switch of the connec- tor as required:

Y/C: When connecting to a TV or VCR which accepts Y/C signals and uses an S-VIDEO cable. CVBS: When connecting to a TV or VCR which does not accept Y/C signals and uses an audio/ video cable.