JVC LYT0002-088B Exchanging FADE/WIPE Effects, Accessmenu FADER/WIPE Customize, Select NEW Effect

38EN

RECORDING

Advanced Features (Cont.)

Exchanging FADE/WIPE Effects

You can replace the 5 effects currently appearing in the menu with 5 others. After exchanging, the new effects appear in the Fader/Wipe Menu.

LCD monitor

WIDE MODE	O FF
ZOOM	2 0X
D I S	OFF
GA I N UP	AGC

TO	FADER / W IPE			MENU
TO	P . AE / EFFECT			MENU
TO DAT E / TIME MENU
TO SYSTEM MENU
W.BALANCE			AUTO
END		I TEM	–/+ BUTTON
		SET	MENU BUTTON

Recording Menu

FADER / W IPE CUSTOM I ZE

1WH WH I TE FADER

2BK BLACK FADER

3P D I SSOLVE

4	CORNER W I PE
5	W INDOW W I PE
END	I TEM	–/+ BUTTON
	SET	MENU BUTTON

FADER/WIPE Customize

Power Dial

AUTO

MENU

MANUAL

Shooting mode selector

1 SELECT OPERATION MODE

First make sure the LCD monitor is open fully. Turn the Power Dial to "REC" while pressing down the lock button located on the dial, and set the shooting mode selector to "MANUAL".

2 ACCESS RECORDING MENU

Press MENU. The Recording Menu appears in the LCD monitor.

3 ACCESSMENU FADER/WIPE CUSTOMIZE

Place the pointer next to “TO FADER/WIPE MENU” by pressing the –/+button, then press MENU. The Fader/Wipe Customize Menu appears.

4 SELECT EFFECT TO BE REPLACED Place the pointer next to the number of the effect you want to replace by pressing the –/+button, then press MENU. The cursor stops blinking.

5 SELECT NEW EFFECT

Cycle through the remaining effects by pressing the –/+button and stop when the one you want is displayed. Press MENU.

•The pointer automatically moves to “END”. •To replace other effects, repeat steps 4 and 5.

6 CLOSE MENU

Press MENU twice. Selection is complete, and you can use the new effects during recording (☞ pg. 34).

To use the exchanged FADE/WIPE effects, refer to the following pages:

•Fades and Wipes	☞ pg. 35
•Picture Wipe/Dissolve	☞ pg. 36
•Random Variations	☞ pg. 37