JVC LYT0002-088B manual Insert Editing, Find Edit OUT Point Start Recording

66EN EDITING (Cont.)

Insert Editing

You can record a new scene into a previously recorded tape, replacing a section of the original recording with minimal picture distortion at the in- and out-points. The original audio remains unchanged.

NOTE:

Insert Editing is not possible on a tape recorded in the LP mode or on a blank portion of a tape.

Power Dial

	RM-V708U or
	RM-V710U (provided)
			RECORDING
	T	W	START/STOP
			DISPLAY
6w	Remote sensor		INSERT
			PLAY

12:34

PAUSE

REW(IND)

1	FIND EDIT OUT POINT	4		START RECORDING
	Open the LCD monitor and turn the Power			Press RECORDING START/STOP to begin
	Dial to "PLAY" while pressing down the lock			editing.
	button located on the dial. Confirm the time
				•Confirm the insert at the time code you
	code at this point (☞ pg. 55).
2				checked in step 1.
	FIND EDIT IN POINT	5
				PAUSE DURING EDITING
	Press REW until the point is located, then press
	PAUSE.			Press RECORDING START/STOP. Press again
3			to resume editing.
	PREPARE FOR INSERT EDITING	6
				STOP EDITING
	Press and hold INSERT on the remote control,
	then press PAUSE. “6w” and the Time Code			Press RECORDING START/STOP, then press
	(min.:sec.) appear in the LCD monitor.		STOP.

NOTES:

●When performing Insert Editing, the tape’s Video Area and Sub-Code Area (☞ pg. 6) are rewritten, so the date and time information changes.

●If you perform Insert Editing onto a blank space on the tape, the audio and video may be disrupted. Make sure you only edit recorded areas.

●During Insert Editing, when the tape moves to scenes recorded in the LP mode or a blank portion, Insert Edting stops and "ERROR: REFER MANUAL" appears on the LCD monitor.