JVC LYT0002-0R1A, 0797TOV*UN*SN manual End of its service life, images

70EN TROUBLESHOOTING (Cont.)

SYMPTOM POSSIBLE CAUSES CORRECTIVE ACTION

25.When shooting a subject illuminated by bright light, vertical lines appear.

25. •This is a result of	25.
exceedingly high contrast,	————
and is not a malfunction.

26. There are disturbances in	26. •If Audio Dubbing or Insert	26. • Use a new, or infrequently
audio and video.	Editing have been performed	used, tape for Audio
	repeatedly on the same	Dubbing and Insert Editing
	portion of the tape,	(☞ pg. 65, 66).
	disturbance to the sound
	and picture may result.
27. During recording, the	27. •“DISPLAY” is set to “OFF” in	27. • Set “DISPLAY” to “ON” in
date/time does not	the Date/Time Menu.	the Date/Time Menu
appear.	•Interface shooting is	(☞pg. 11).
	performed.	• During interface shooting,
		the date/time does not
		appear (☞ pg. 23).
		• Press the IND. ON/OFF
		button for longer than 1
		second to make the indica-
		tors appear (☞ pg. 22).
28. The indicators and	28. •“ON SCREEN” is set to	28. • Set “ON SCREEN” to “ON”
messages do not appear	“OFF” in the Date/Time	in the Date/Time Menu
on screen.	Menu.	(☞ pg. 33).
		• Press the IND. ON/OFF
		button for longer than 1
		second to make the indica-
		tors appear (☞ pg. 22).
29. The indicators do not	29. •You have made the	29. • Press the IND. ON/OFF
appear on the LCD	indicators disappear.	button for longer than 1
monitor or in the		second to make the indica-
viewfinder.		tors appear (☞ pg. 22).
30. Images on the LCD	30. •In places subject to low	30. • Adjust the brightness and
monitor appear dark or	temperature, images	angle of the LCD monitor
whitish.	become dark due to the	(☞ pg. 22, 23).
	characteristics of the LCD
	monitor. When this
	happens, the displayed
	colours differ from those that
	are actually recorded. This is
	not a defect of the
	camcorder.
	• When the LCD monitor's
	fluorescent light reaches the
	end of its service life, images
	on the LCD monitor become
	dark. Consult your nearest
	JVC dealer.
31. The rear of the LCD	31. •The light used to illuminate	31. • Close the LCD monitor to
monitor is hot.	the LCD monitor causes it to	turn it off or set the Power
	become hot.	Dial to “OFF”, and let the
		unit cool down (☞ pg. 19).
32. The indicators and the	32. •This may occur when the	32.
image colour on the LCD	surface or the edge of the	————
monitor are not clear.	LCD monitor is pressed.
33. Images on the LCD	33. The speaker volume is too	33. • Turn the speaker volume
monitor are jittery.	great.	down (☞ pg. 49).
34. The LCD monitor and the	34.	34. • Wipe them gently with soft
lens have become dirty	————	cloth. Wiping strongly can
(ex. fingerprints).		cause damage.