CLOSE MAIN MENU
Press MENU.
START DELAYED RECORDING
Press the Recording Start/Stop button. If you set the tally lamp to “ON” (☞ pg. 27), it begins blinking, and the blinking frequency increases about 5 seconds before recording is to start. Once recording begins, the lamp stops blinking but stays lit.
SET INTERVAL TIME
5 Press – to move the highlight bar down to “Interval
Timer”, press NEAR, then press + or – to cycle through the choices. Stop when the desired time appears. Choose from “15S”, “30S”, “1min”, “5min”, or select to turn the function “OFF”. Then press FAR twice to return to the Main Menu screen.
ACCESS SUB MENU SCREEN
Press MENU.
ACCESS MAIN MENU SCREEN
Set the Shooting Mode selector to “PRESET”.
SELECT MODE
Make sure the lens cover is open, then set the Power switch to “CAMERA”.
1
2
3
4 Press – to move the highlight bar down to “Sub Menu”, then press NEAR. The Sub Menu screen appears.
You can set the delay between pressing the Recording Start/Stop button and the actual start of recording. If you secure the camcorder, you (or whomever is operating the camcorder) can enter the scene before recording starts.
ENGAGE RECORD-STANDBY MODE
30EN
RECORDING
AdvancedFeatures(cont.)
| Interval Timer Indicator | |||
Recording |
|
|
| 1min |
|
|
| ||
Time Indicator |
|
|
| 1 s |
|
|
| ||
|
|
|
+
FAR NEAR
MENU
–
Tally lamp
START/STOP
INT. TIME
REC TIME
| Shift Zoom | OFF |
| Tele Macro | OFF |
| Gain Up | AGC |
| Color Filter | NOR . |
| Tape Length | T45 |
| Title |
|
| Date/Time |
|
| Sub Menu |
|
|
|
|
Main Menu Screen |
| |
|
|
|
| Tally/EL | ON |
|
|
|
| Interval Timer | OFF |
| Rec Time | OFF |
| JLIP ID NO . | 07 |
|
|
|
6
7
To Release Self-Timer . . .
.... while the tally lamp is blinking, press the Recording
Start/Stop button to stop the blinking, then set
“Interval Timer” to “OFF” or press INT. TIME on the remote control until “” disappears.
.... while the tally lamp is lit but not blinking, press set
“Interval Timer” to “OFF” or press INT. TIME on the remote control until “” disappears.
NOTE:
Instead of performing steps 2 – 6, you can set the interval time by pressing INT. TIME on the remote control.