Panasonic NV-GS180EB Remote control usable range, Selecting the remote control mode

Before using

ªRemote control usable range

≥The distance between the remote control and the camera: Within approx. 5 m

Angle: Approx. 10o up and 15o down, left, and right

ªSelecting the remote control mode

If 2 cameras are used simultaneously, set the mode for one pair of movie camera and remote control to [VCR1] and that of the other pair to [VCR2]. This will prevent interference between the 2 pairs. (The default setting is [VCR1]. When the button-type battery is replaced, the setting will revert to the default [VCR1].)

1 Setting on the camera:

Set [SETUP] >> [REMOTE] >> [VCR1] or [VCR2].

2 Setting on the remote control:

2 1

[VCR1]:

Press [D] and [∫] simultaneously. 1 [VCR2]:

Press [E] and [∫] simultaneously. 2

ªConcerning the button-type battery

≥When the button-type battery runs down, replace it with a new battery (part number: CR2025). The battery is normally expected to last about 1 year, but it depends on operation

frequency.

≥Keep the button-type battery out of the reach of children.

≥If the remote control mode of the camera and that of the remote control do not match with each other, “REMOTE” will appear. When the remote control is operated for the first time after the camera is turned on, “CHECK REMOTE

MODE” (-48-) will appear and operation is impossible. Set the same remote control mode.

≥The remote control is intended for indoor operation. Outdoors or under strong light, the movie camera may not operate properly even within the usable ranges.

≥Within a 1 metre range, you can operate the remote control from beside the remote control sensor (LCD monitor side) of the movie camera.

19

VQT0T87