Panasonic PV-DV53 operating instructions CAMERA/VCR Mode, Important Note

Page 63

Electronic Viewfinder/LCD Monitor Indications

Here are some of the basic indications which will appear on the Palmcorder EVF and LCD Monitor. Only Date and Time indications will be recorded onto the tape.

CAMERA/VCR Mode

a

g

h

b

c

d

e

f

a

Battery Remaining

FULL

 

h Counter/Time Code

The indication switches as shown below when the desired “C. DISPLAY” mode is selected from the menu.

b Tape Remaining

EMPTY

(Menu OSD: pp. 60, 62)

LinearTime Counter Memory Counter

(AY-DVM30EJ) (AY-DVM60EJ)

R0:30R1:00

R0:00

R0:00

It will take several seconds for the tape remaining indicator to operate after the tape starts moving.

c CINEMA Indication (Menu OSD: p. 59)

d Digital Zoom and other Digital Functions (Menu OSD: p. 59)

This display appears when the digital zoom function has been activated.

e Playback Effect (Menu OSD: p. 61) This display appears when SEPIA or B/W is selected in VCR menu.

f

Volume Display (p. 28)

 

The volume bar appears when the

 

volume of the built-in speaker is being

 

adjusted.

g Tape Speed Indication

(Menu OSD: p. 59)

Indicates the tape speed (SP or LP).

Time Code

Memory Counter M 0:00.00

The Palmcorder will stop whenever it reaches the point where the counter was previously set to M 0:00.00 during audio dub, fast forward, or rewind.

Time Code 0h00m00s00f

The Palmcorder calculates and displays exactly where you are on any tape in terms of hours, minutes, seconds, and frames (30 frames = 1 second).

This display cannot be reset.

IMPORTANT NOTE:

Display must be set to ALL for MF, AE, W.BALANCE or BACK LIGHT indications to be displayed on the EVF or LCD Panel when selected.

C.RESET does not work when C. DISPLAY is set to T.CODE.

For Your Information

63

Image 63
Contents Operating Instructions PV-DV53 Safety PrecautionsThings You Should Know Above markings are located on the appliance bottom coverImportant Safeguards Important Safeguards Table of Contents Record Speed/Playback Time Before UsingHow to remove the Sensor tag Unpack your PalmcorderHand Strap Adjust the LengthEasy Cassette Eject/Insertion Attaching the Shoulder StrapTo turn Self Demo back on Using the Built-in LightSelf Demo Mode Set Power to CameraMonitor, and swing it fully open Insert the Battery PackQuick Guide Insert CassetteTo Watch Playback in the LCD Liquid Crystal Display Camera RecordingBatt Release Charge the Battery Pack on the AC AdaptorInsert the Battery Pack Remove the Battery Pack About the Flashing of the Charge LampSupplying Power Battery CareUse AC Adaptor Example Setting the ClockSet the Date and Time Camera VCR FunctionsVCR Main menu Using the Palmcorder MenuDisplaying the Menu Camera Main menuEVF To conserve powerCamera Recording Simple RecordingEVF/LCD Using the LCD MonitorTo adjust the LCD/EVF Brightness or Color Start recordingPress Photoshot in Record/Pause mode Digital PhotoShot ModeProgressive PhotoShot Mode Set Power to Camera Press Photoshot in Record/PauseZoom quickly Set Power to Camera Zoom slowlyZoom Recording Check2STILL JOG KEY 2MENU 5REC Pause 1POWERRecording Still Pictures Self RecordingStart recording Press Back Light to activate Special Effect FeaturesCinema Mode BacklightProgram AE Audio/Video Fade In/Out FadeFade Out Following cases, the indication flashes Advanced SettingsFor manual White Balance adjustment White BalanceAuto Focus Manual FocusMacro Focus for close-ups Auto Shutter High Speed ShutterAdjusting the Iris Manually Monitor Playback using the LCDConnecting Earphone not supplied Playback Your RecordingsEVF/LCDR Adjusting the VolumeRepeat Playback Blank SearchREWIND/SEARCH Rapid Visual SearchStill Picture Fast Forward/Rewind CheckJOG KEY 1PLAY Rotate JOG KEY to adjustVariable Speed Search Jog Frame by Frame SearchSlow Strobe Multi ModeFast NormalStart playback or begin a recording View Recording/Playback on your TVTV with AUDIO/VIDEO in Jacks OUTDigital Zoom Digital FeaturesJOG KEY 2MENU 1POWER 5PLAY Set Power to VCRMagicPix Images Power 3REC/PAUSE Bplay Dual Digital Electronic Image Stabilization System D.E.I.SI.S. may not function when Other Digital Functions To use the Wipe functionTo use the MIX function Photoshot KEY 1POWER 2MENU 7REC Pause Camera StillPicture in Picture PinP Main Picture Picture in Picture PinP still image12 bit Editing FeaturesAudio Dubbing using the Built-in Microphone Set Power to VCR Press PLAY. Then press7PAUSE MIXPress Pause to stop Audio Dubbing Monitor with your TV Copying your Tapes to VHS CassetteInsert a pre-recorded tape into Copying from Digital Equipment dubbingRecording Palmcorder Pause 6STOP 4RECPC Connection with DV Interface Cable i.LINK PC ConnectionPhotovu Link Driver Optional System Requirements for Photovu Link Driver OptionalConnection Running the Software Photovu Link OptionalUsing Tape Image Data Palmcorder Accessory System Visa Palmcorder Accessory Order FormHandle bulb gently. Excessive force may cause bulb to crack Replacing the BulbMixture Approximate Brightness ValuesSpecifications Lens Hood Area Operation Caution Before Requesting ServiceCleaning Care for Video Heads Tape Operations CautionSymptom Correction Request for Service NoticeFor On-Screen Displays OSDLimited Warranty Limited WarrantyAccessory Purchases Customer Services DirectoryAdvertencia del FCC Precauciones para su seguridadInserte el Cassette Inserte de la bateríaAutomáticamente Grabación con la cámaraCuando el monitor LCD se enchuentra Totalmente abierto, el visor se DesactivaCamera Mode Menu Screen Beep Sound 10 11VCR Mode Menu Screen 11 C.RESET p REC Speed pAudio DUB p Important Note CAMERA/VCR ModeCHK RECPhoto PauseRear View Index of ControlsFront View Side ViewBack View Top ViewPower Lamp Charge Lamp Tripod Receptacle AC Power Cord pp VCR DC Output ConnectorUnderside View AC Adaptor Index Menu OSDPhotovu Link