Panasonic AK-HC1800N operating instructions Interface cable specifications

Page 11

Major operating controls and their functions

Use the multi-cable provided with the AK-HRP150G when supplying power from the AK‑HRP150G.

Use the cable provided with the AW-PH650 when supplying power from the AW-PH650.

When supplying power from the AW-PH400, use the AW-CA15H29G or the AW‑CAK4H1G cable kit depending on the configuration of the control system.

Use the AW-CA15H29G when supplying power from the AW-PH405.

When supplying power separately, ensure that the specifications of the interface cable given below are satisfied.

Interface cable specifications

Use a cable with a performance equivalent or superior to the specifications given below.

AK-HC1800N

(High-density D-sub 15-pin connector)

G/L GND

GND

DC power supply input

(+12 V)

Not used

Not used

G/L signal input

Not used

GND

DC GND

TX_N(EIA422)/

TXD(EIA232C) output

GND

TX_P(EIA422) output

RX_N(EIA422)/

RXD(EIA232C) input

GND

RX_P(EIA422) input

DC GND

DC power supply input

(+12 V)

Power input: +12 V ±10 %, 5 A or more

Cable length: 5 m or less

G/L GND

G/L signal input

GND

RX_N(EIA422)/

RXD(EIA232C) input

RX_P(EIA422) input

TX_N(EIA422)/

TXD(EIA232C) output

TX_P(EIA422) output

Connector: DHW10-153F200		 Use a twisted-pair cable.
	made by Advanced Connectek Inc.
Cover:	DE-C8-J9-F5-1R
	made by Japan Aviation Electronics Industry, Ltd.

- 11 -

Image 11

Contents Multi Purpose Camera Operating InstructionsDo not Open FCC NoteIndicates safety information Important Safety Instructions Accessories ContentsNew 2/3˝ 2.2 million-pixel CCD is employed H  CharacteristicsBit A/D conversion and brand-new DSP featured IntroductionDON’TS Precautions for useBottom view Rear view Front view Lens mount  HD SDI output connector HD SDI OUT AK-HC1800N Interface cable specifications Tally output connector Tally OUT How to set the lens How to installConfiguration example 1 Connection of camera controller How to set up the systemConfiguration example 2 High-speed P/T system Configuration example 3 High-speed P/T system AW-PH650 BAR Control exercised from the AW-CB400When the LCD panel is in the pedestal adjustment mode Procedure for camera menu operation AW-RP655Mode How to set up the system Start shooting Operation procedureAdjust the white balance Adjust the black balanceAuto iris power zoom lens How to adjustFlange back adjustment for zoom lens Lens iris gain volume adjustmentColor temperature and white balance adjustment reference White balance adjustmentGen-lock adjustment Black balance adjustmentIntelligent functions Automatic color temperature adjustment method Automatic video level adjustment methodTOP menu Setting of menu itemsHow to display the menus  Using AK-HRP150G camera controllerCorrectdig OFF, on  Maintenance menuBlack Shading Detection Gamma PEDESTAL, GammaPedestal -200 to +200 Pedestal -100 to +100Cine Gamma Select Video REC, Film REC Gamma OFF, onBlack Gamma OFF, on DRS OFF, onFlare OFF, on FlareFlare 000 to Knee Slope KNEE, White Clip When the Knee is set toManual Knee Point Knee Point -25.00% to +25.00%Knee Level 100% to 109% High Color OFF, on KNEE, White ClipKnee OFF, MANUAL, Auto White Clip OFF, onKnee Aperture OFF, on Detail Detail OFF, onDetail Source Detail Slim Detail OFF, onSkin GET OFF, on Skin Tone Detail Skin Tone DTL OFF, onIris PEAK/AVE 000 to Iris Mode LENS, CAMGAIN, Auto Iris Iris Level 000 toSuper Gain Mode S.GAIN1, S.GAIN2, S.GAIN3PED Offset -200 to +200 35 to 0.75 DRS OFF -10 to +10 DRS onMatrix Table A, B Frame Mode MatrixColor Correction SAT/PHASE -63 to +63LOW, MID, HIGH, S.GAIN1 to Setting menuLighting TUNGSTEN, Daylight Gain SelectBAR SEL Matrix Table OFF, A, BColor Correction OFF, on Digital Extender OFFAWB OK FormatStatus OFF, on AWB ActiveMenu SEL Video MENU, Film Menu ABB OKOUT Range RGB Menu on BAR OFF, onShutter Speed Shutter Shutter Mode OFF, ON, SynchroSD-HD Phase Fine -99 to +99 PHASE-COARSE -060 to +060PHASE-FINE -045 to +045 SD-HD Phase CRS -4 to +4Protocol 1 to ProtocolIntelligent MANUAL, AUTO, Lock INTELLIGENT1Gain -6dB to 72dB ND-FIL CLEAR, 1/4, 1/16, 1/64ATW AGCAGC Speed 1 to INTELLIGENT1 Intelligent Mode AGC, ATW, AGC+ATWND Filter Select CLEAR, 1/4, 1/16, 1/64, AutoHI Light Detect 01 to INTELLIGENT1 AGC Gain Step NORMAL, MAXATW Speed 1 to Iris Range 1, 2ATW Area 25%, 50%, 90% NORMAL, SPORTS, SN, User The AGC control mode is set here AGC ModeFrame MIX MIX +00dB, +06dBINTELLIGENT1 SUB Menu INTELLIGENT2 INTELLIGENT2 Intelligent SETIris on Lock LOCK, MANUAL, Panel ATW Width 1 toCamera ID menu Execute Mode LOAD/STOREFile Operation menu LOAD/STORE fromMenu list Setting of menu items Maintenance Color SAT/PHASE Correction Setting of menu items Unit inch mm AppearanceInput/output signal SpecificationsEastern Zone