Panasonic AK-HC1800N GAIN, Auto Iris, Iris Level 000 to, Iris PEAK/AVE 000 to, Iris Gain 01 to

Page 39

Setting of menu items

MAINTENANCE menu

[8]GAIN, AUTO IRIS

LOW GAIN [–06dB to 30dB]

MID GAIN [–06dB to 30dB]

HIGH GAIN [–06dB to 30dB]

For setting the amount by which the gain is to be increased when LOW, MID or HIGH has been selected by GAIN SELECT.

A.IRIS LEVEL [000 to 100]

For adjusting the target level (brightness) of the auto iris.

A.IRIS PEAK/AVE [000 to 100]

For setting the ratio between the auto iris light-metering peak value and average value.

A.IRIS WINDOW [NORM1, NORM2, CENTR] For setting the auto iris light-metering area.

NORM1: The light is metered on the entire screen (except around the edges).

NORM2: The light is metered on the entire screen (except at the top).

CENTR: The light is metered only in the area at the screen center.

IRIS MODE [LENS, CAM]

For switching between the iris gain control on the lens (LENS) and the menu (CAM) to adjust the focusing speed of the auto iris. Normally, LENS is selected, and the speed is adjusted using the iris gain control on the lens.

IRIS GAIN [01 to 10]

For adjusting the iris gain when CAM has been selected as the IRIS MODE setting.

- 39 -

Image 39

Contents Multi Purpose Camera Operating InstructionsDo not Open FCC NoteIndicates safety information Important Safety Instructions Accessories ContentsNew 2/3˝ 2.2 million-pixel CCD is employed H  CharacteristicsBit A/D conversion and brand-new DSP featured IntroductionDON’TS Precautions for useBottom view Rear view Front view Lens mount  HD SDI output connector HD SDI OUT AK-HC1800N Interface cable specifications Tally output connector Tally OUT How to set the lens How to installConfiguration example 1 Connection of camera controller How to set up the systemConfiguration example 2 High-speed P/T system Configuration example 3 High-speed P/T system AW-PH650 BAR Control exercised from the AW-CB400When the LCD panel is in the pedestal adjustment mode Procedure for camera menu operation AW-RP655Mode How to set up the system Start shooting Operation procedureAdjust the white balance Adjust the black balanceAuto iris power zoom lens How to adjustFlange back adjustment for zoom lens Lens iris gain volume adjustmentColor temperature and white balance adjustment reference White balance adjustmentGen-lock adjustment Black balance adjustmentIntelligent functions Automatic color temperature adjustment method Automatic video level adjustment methodTOP menu Setting of menu itemsHow to display the menus  Using AK-HRP150G camera controller Maintenance menu Black Shading DetectionCorrectdig OFF, on Gamma PEDESTAL, GammaPedestal -200 to +200 Pedestal -100 to +100Cine Gamma Select Video REC, Film REC Gamma OFF, onBlack Gamma OFF, on DRS OFF, onFlare Flare 000 toFlare OFF, on Knee Slope KNEE, White Clip When the Knee is set toManual Knee Point Knee Point -25.00% to +25.00%Knee Level 100% to 109% High Color OFF, on KNEE, White ClipKnee OFF, MANUAL, Auto White Clip OFF, onKnee Aperture OFF, on Detail Detail OFF, onDetail Source Detail Slim Detail OFF, onSkin GET OFF, on Skin Tone Detail Skin Tone DTL OFF, onIris PEAK/AVE 000 to Iris Mode LENS, CAMGAIN, Auto Iris Iris Level 000 toSuper Gain Mode S.GAIN1, S.GAIN2, S.GAIN3PED Offset -200 to +200 35 to 0.75 DRS OFF -10 to +10 DRS onMatrix Table A, B Frame Mode MatrixColor Correction SAT/PHASE -63 to +63LOW, MID, HIGH, S.GAIN1 to Setting menuLighting TUNGSTEN, Daylight Gain SelectBAR SEL Matrix Table OFF, A, BColor Correction OFF, on Digital Extender OFFAWB OK FormatStatus OFF, on AWB ActiveMenu SEL Video MENU, Film Menu ABB OKOUT Range RGB Menu on BAR OFF, onShutter Speed Shutter Shutter Mode OFF, ON, SynchroSD-HD Phase Fine -99 to +99 PHASE-COARSE -060 to +060PHASE-FINE -045 to +045 SD-HD Phase CRS -4 to +4Protocol 1 to ProtocolIntelligent MANUAL, AUTO, Lock INTELLIGENT1Gain -6dB to 72dB ND-FIL CLEAR, 1/4, 1/16, 1/64ATW AGCAGC Speed 1 to INTELLIGENT1 Intelligent Mode AGC, ATW, AGC+ATWND Filter Select CLEAR, 1/4, 1/16, 1/64, AutoHI Light Detect 01 to INTELLIGENT1 AGC Gain Step NORMAL, MAXIris Range 1, 2 ATW Area 25%, 50%, 90%ATW Speed 1 to NORMAL, SPORTS, SN, User The AGC control mode is set here AGC ModeFrame MIX MIX +00dB, +06dBINTELLIGENT1 SUB Menu INTELLIGENT2 INTELLIGENT2 Intelligent SETIris on Lock LOCK, MANUAL, Panel ATW Width 1 toCamera ID menu Execute Mode LOAD/STOREFile Operation menu LOAD/STORE fromMenu list Setting of menu items Maintenance Color SAT/PHASE Correction Setting of menu items Unit inch mm AppearanceInput/output signal SpecificationsEastern Zone