Panasonic AK-HC1800N operating instructions Agc, Atw

Page 52

Setting of menu items

2SETTING menu

[5]INTELLIGENT1

When AUTO or LOCK has been set as the operation mode, restrictions apply to the settings of some of the other menus, as indicated below.

AGC

• The auto iris function is operational regardless of whether the auto iris setting from the camera controller is ON or OFF.

• The setting from the menu and camera controller is not reflected for GAIN SELECT on the SETTING menu.

• The LOW GAIN, MID GAIN, and HIGH GAIN settings for GAIN/AUTO IRIS on the MAINTENANCE menu are not reflected.

• The S.GAIN settings (gain, detail, gamma, and pedestal settings) on the MAINTENANCE menu are not reflected.

• The ND FILTER setting for R/B GAIN on the MAINTENANCE menu is not reflected.

ATW

• R/B GAIN can be controlled from the menu and camera controller, but the white balance is automatically adjusted if the subject is identified as being white.

• AWB is executed in a 25 % 25 % area at the center regardless of the ATW AREA setting.

However, what is determined to be the ATW color temperature is not always consistent with AWB, so the white balance may be changed by ATW after AWB has been executed.

- 52 -

Image 52
Contents Operating Instructions Multi Purpose CameraFCC Note Do not OpenIndicates safety information Important Safety Instructions Contents AccessoriesCharacteristics Bit A/D conversion and brand-new DSP featuredIntroduction New 2/3˝ 2.2 million-pixel CCD is employed H Precautions for use DON’TSFront view Bottom view Rear view Lens mount  HD SDI output connector HD SDI OUT Interface cable specifications AK-HC1800N Tally output connector Tally OUT How to install How to set the lensHow to set up the system Configuration example 1 Connection of camera controllerConfiguration example 2 High-speed P/T system Configuration example 3 High-speed P/T system AW-PH650 Control exercised from the AW-CB400 BARProcedure for camera menu operation AW-RP655 When the LCD panel is in the pedestal adjustment modeMode How to set up the system Operation procedure Adjust the white balanceAdjust the black balance Start shootingHow to adjust Flange back adjustment for zoom lensLens iris gain volume adjustment Auto iris power zoom lensWhite balance adjustment Color temperature and white balance adjustment referenceBlack balance adjustment Gen-lock adjustmentIntelligent functions Automatic video level adjustment method Automatic color temperature adjustment methodSetting of menu items How to display the menus Using AK-HRP150G camera controller TOP menuBlack Shading Detection  Maintenance menuCorrectdig OFF, on PEDESTAL, Gamma Pedestal -200 to +200Pedestal -100 to +100 GammaGamma OFF, on Black Gamma OFF, onDRS OFF, on Cine Gamma Select Video REC, Film RECFlare 000 to FlareFlare OFF, on KNEE, White Clip When the Knee is set to Manual Knee PointKnee Point -25.00% to +25.00% Knee SlopeKnee Level 100% to 109% KNEE, White Clip Knee OFF, MANUAL, AutoWhite Clip OFF, on High Color OFF, onDetail Detail OFF, on Knee Aperture OFF, onDetail Slim Detail OFF, on Detail SourceSkin Tone Detail Skin Tone DTL OFF, on Skin GET OFF, onIris Mode LENS, CAM GAIN, Auto IrisIris Level 000 to Iris PEAK/AVE 000 toMode S.GAIN1, S.GAIN2, S.GAIN3 Super Gain35 to 0.75 DRS OFF -10 to +10 DRS on PED Offset -200 to +200Frame Mode Matrix Matrix Table A, BSAT/PHASE -63 to +63 Color CorrectionSetting menu Lighting TUNGSTEN, DaylightGain Select LOW, MID, HIGH, S.GAIN1 toMatrix Table OFF, A, B Color Correction OFF, onDigital Extender OFF BAR SELFormat Status OFF, onAWB Active AWB OKABB OK OUT Range RGBMenu on BAR OFF, on Menu SEL Video MENU, Film MenuShutter Shutter Mode OFF, ON, Synchro Shutter SpeedPHASE-COARSE -060 to +060 PHASE-FINE -045 to +045SD-HD Phase CRS -4 to +4 SD-HD Phase Fine -99 to +99Protocol Protocol 1 toINTELLIGENT1 Gain -6dB to 72dBND-FIL CLEAR, 1/4, 1/16, 1/64 Intelligent MANUAL, AUTO, LockAGC ATWINTELLIGENT1 Intelligent Mode AGC, ATW, AGC+ATW ND Filter SelectCLEAR, 1/4, 1/16, 1/64, Auto AGC Speed 1 toINTELLIGENT1 AGC Gain Step NORMAL, MAX HI Light Detect 01 toATW Area 25%, 50%, 90% Iris Range 1, 2ATW Speed 1 to AGC Mode NORMAL, SPORTS, SN, User The AGC control mode is set hereMIX +00dB, +06dB Frame MIXINTELLIGENT1 SUB Menu INTELLIGENT2 Intelligent SET INTELLIGENT2ATW Width 1 to Iris on Lock LOCK, MANUAL, PanelCamera ID menu Mode LOAD/STORE File Operation menuLOAD/STORE from ExecuteMenu list Setting of menu items Maintenance Color SAT/PHASE Correction Setting of menu items Appearance Unit inch mmSpecifications Input/output signalEastern Zone