Panasonic AK-HC1800N Operation procedure, Adjust the white balance, Adjust the black balance

Page 22

Operation procedure

1 Turn on the power of each equipment.

2 Properly adjust the light for the object.

3 Adjust the flange back of the lens, the iris and the focus.

Flange back must be adjusted when the camera is used for the first time or after replacement of the lens.

4 Adjust the white balance.

This adjustment is needed when the camera is used for the first time or after leaving unused for a long time.

The adjustment is necessary when the lighting condition or brightness is changed.

After adjusting the white balance once, re-adjustment is not needed under the same condition.

5 Adjust the black balance.

This adjustment is needed when the camera is used for the first time or after leaving unused for a long time.

The adjustment is necessary when the ambient temperature is greatly changed or at the change of season.

After adjusting the black balance once, re-adjustment is not needed under the same condition.

6 Start shooting.

(After shooting, be sure to turn off the power of each equipment connected.)

- 22 -

Image 22

Contents Operating Instructions Multi Purpose CameraFCC Note Do not OpenIndicates safety information Important Safety Instructions Contents AccessoriesIntroduction CharacteristicsBit A/D conversion and brand-new DSP featured New 2/3˝ 2.2 million-pixel CCD is employed H Precautions for use DON’TSFront view Bottom view Rear view Lens mount  HD SDI output connector HD SDI OUT Interface cable specifications AK-HC1800N Tally output connector Tally OUT How to install How to set the lensHow to set up the system Configuration example 1 Connection of camera controllerConfiguration example 2 High-speed P/T system Configuration example 3 High-speed P/T system AW-PH650 Control exercised from the AW-CB400 BAR Procedure for camera menu operation AW-RP655 When the LCD panel is in the pedestal adjustment modeMode How to set up the system Adjust the black balance Operation procedureAdjust the white balance Start shootingLens iris gain volume adjustment How to adjustFlange back adjustment for zoom lens Auto iris power zoom lensWhite balance adjustment Color temperature and white balance adjustment referenceBlack balance adjustment Gen-lock adjustmentIntelligent functions Automatic video level adjustment method Automatic color temperature adjustment method Using AK-HRP150G camera controller Setting of menu itemsHow to display the menus TOP menuBlack Shading Detection  Maintenance menuCorrectdig OFF, on Pedestal -100 to +100 PEDESTAL, GammaPedestal -200 to +200 GammaDRS OFF, on Gamma OFF, onBlack Gamma OFF, on Cine Gamma Select Video REC, Film RECFlare 000 to FlareFlare OFF, on Knee Point -25.00% to +25.00% KNEE, White Clip When the Knee is set toManual Knee Point Knee SlopeKnee Level 100% to 109% White Clip OFF, on KNEE, White ClipKnee OFF, MANUAL, Auto High Color OFF, onDetail Detail OFF, on Knee Aperture OFF, onDetail Slim Detail OFF, on Detail SourceSkin Tone Detail Skin Tone DTL OFF, on Skin GET OFF, onIris Level 000 to Iris Mode LENS, CAMGAIN, Auto Iris Iris PEAK/AVE 000 toMode S.GAIN1, S.GAIN2, S.GAIN3 Super Gain35 to 0.75 DRS OFF -10 to +10 DRS on PED Offset -200 to +200Frame Mode Matrix Matrix Table A, BSAT/PHASE -63 to +63 Color CorrectionGain Select Setting menuLighting TUNGSTEN, Daylight LOW, MID, HIGH, S.GAIN1 toDigital Extender OFF Matrix Table OFF, A, BColor Correction OFF, on BAR SELAWB Active FormatStatus OFF, on AWB OKMenu on BAR OFF, on ABB OKOUT Range RGB Menu SEL Video MENU, Film MenuShutter Shutter Mode OFF, ON, Synchro Shutter SpeedSD-HD Phase CRS -4 to +4 PHASE-COARSE -060 to +060PHASE-FINE -045 to +045 SD-HD Phase Fine -99 to +99Protocol Protocol 1 toND-FIL CLEAR, 1/4, 1/16, 1/64 INTELLIGENT1Gain -6dB to 72dB Intelligent MANUAL, AUTO, LockAGC ATWCLEAR, 1/4, 1/16, 1/64, Auto INTELLIGENT1 Intelligent Mode AGC, ATW, AGC+ATWND Filter Select AGC Speed 1 toINTELLIGENT1 AGC Gain Step NORMAL, MAX HI Light Detect 01 toATW Area 25%, 50%, 90% Iris Range 1, 2ATW Speed 1 to AGC Mode NORMAL, SPORTS, SN, User The AGC control mode is set hereMIX +00dB, +06dB Frame MIXINTELLIGENT1 SUB Menu INTELLIGENT2 Intelligent SET INTELLIGENT2ATW Width 1 to Iris on Lock LOCK, MANUAL, PanelCamera ID menu LOAD/STORE from Mode LOAD/STOREFile Operation menu ExecuteMenu list Setting of menu items Maintenance Color SAT/PHASE Correction Setting of menu items Appearance Unit inch mmSpecifications Input/output signalEastern Zone