Panasonic AG-EZ50UP Power Supply, Charging Time and Available Recording Time, Using the Battery

13

Power Supply

ªUsing the AC Adaptor

1		1	Slide the Viewfinder backward and then tilt it upward.
		2	Insert the battery-shaped connector of the DC Cable into the
		3	Battery Holder on the Camera/Recorder.
	2		Connect the DC connector plug to the [DC OUT] Jack on the
		4	AC Adaptor.
			Connect the AC Adaptor and AC Cable.
		4

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

2

BATT.

PUSH EJECT1

ªUsing the Battery

≥Before use, fully charge the battery.

1Attach the Battery to the AC Adaptor and charge it.

≥Since the Battery will not be charged when the DC Cable is connected to the AC Adaptor, disconnect it.

≥The [CHARGE] Lamp lights up, and charging starts.

≥When the [CHARGE] Lamp goes off, charging is completed.

2Attach the charged Battery to the Camera/Recorder.

Disconnecting the Power Source

Set the [OFF/ON/MODE] Switch to [OFF] and, while pressing the [BATT. EJECT] Button 1, slide the Battery or DC Cable upward to disconnect it.

≥For other notes, see page 46.

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

Charging Time and Available Recording Time

ACharging Time

BMaximum Continuous Recording Time

≥“1 h 20 min.” indicates 1 hour and 20 minutes. ≥Battery VSB0419 is supplied.

≥The hours shown in the table below are approximate hours. The numeric characters in parentheses indicate the recording time when the LCD monitor is used. In actual use, the available recording time may be shorter in some cases.

≥The hours shown in the table below are for continuous recording at a temperature of 68xF (20xC) and humidity of 60 %. If the Battery is charged at a higher or lower temperature, the charging time may become longer.

CGR-D08A/1B	A	1 h.
	B 1 h 10 min. (55 min.)
VSB0419	A	2 h.
CGR-D16A/1B
	B	2 h 25 min. (2 h.)
CGP-D28A/1B	A 3 h 15 min.
	B 4 h 15 min. (3 h 35 min.)
CGR-D53A/1K	A	5 h 20 min.
	B 8 h. (6 h 40 min.)

12