Camera ID DIP Switch Settings SW1 | Samsung SPD-3350, SPD-3750

Installing Your Camera

• Baud Rate Settings

Select the transfer speed of a selected communication protocol.

No.	Baud Rate(BPS)	SW2-#5	SW2-#6
1	2,400	ON	ON
2	4,800	ON	OFF
3	9,600	OFF	OFF
4	19,200	OFF	ON

• Communication Method Settings

Select a communication method for the camera.

	Function	ON	OFF
SW2- #7	Transfer Mode Switch	RS-422(4Wire)	RS-485(2Wire)

• Communication Response Settings

Select a communication response method for the camera and controller: Response or No Response.

	Function	ON	OFF
SW2- #8	Response Mode Switch	Response	No Response

• Termination Settings

To prevent the attenuation of communication signals between the camera and controller, 2 cameras in a longest distance for the camera and controller communication loop must be set up with the termination settings.

Camera Input Position	SW2- #10	SW2- #11
Termination of Longest Path	ON	ON
On the Path	OFF	OFF

Installing Your Camera

• Camera Backup Settings

These settings are useful when the camera or its install base are damaged or malfunctions occur. When replacing the camera or its install base, you can transfer existing presets and sequence information to the replacement using these settings.

Backup Function	SW2- #9	SW2- #12
Backup(IB→D)	OFF	OFF
Backup(D→IB)	ON	OFF
Backup Disable	-	ON

-Backup(IB→D) : Enables transferring the current camera's sequence information to a new camera.

-Backup(D→IB) : Enables transferring the current camera's sequence information to a new install base.

*IB: Install base, D: Dome Camera

Notes

• To use a third party controller with this product, please contact our After-Sales Service or Technology Department.

• AD Protocol Control Method

-Input Camera OSD: 3+Auxiliary On

-Output Camera OSD: 3+Auxiliary Off

-Enter: IRIS Open

-ESC: IRIS Close

• For more information about the protocols, refer to our official website.