Samsung SPD-3350, SPD-3750T user manual Setting 1,2, Timer

Functional Description

25.2.Alarm Output

▶Main Menu/Alarm Setting/Alarm Output

Functional Description

25.3.Aux Output

▶Main Menu/Alarm Setting/Aux Output

Main Menu

①Camera Setting

② Sequence Setting

③ P/T Setting

④ OSD Setting

⑤ Alarm Setting

⑥ Initialize  Status

➡

Alarm Setting

 Alarm Enable OFF

Setting 1,2 :

Enables selecting an Alarm Output method.

-1, 2, 3, 4, and MD on the menu selection indicate the alarm input port and motion detection input. Up to 4 alarm inputs can be set for each MD (Motion Detection) and TRK (Auto Track). 1 alarm output port can be used for more than 2 alarm inputs along with ones for MD and TRK.

✽The TRK function becomes activated only if the Zone mode under Zone Settings under Auto Track 2 is set to Alarm.

Timer :

Enables selecting an Alarm Output method.

Main Menu	AUX Output menu is to operate the camera’s peripheral
	devices such as lamps and sirens through the controller and
① Camera Setting
	switches as well as through network communications.
② Sequence Setting
		On/Off :
③ P/T Setting
④ OSD Setting		- Cancels or activates the Aux function.
⑤ Alarm Setting		Time :
⑥ Initialize		Enables setting up a duration for the Aux output when the
 Status		Aux command is transmitted from the controller.A
➡		duration can be selected from a minimum of 1 second to a
		maximum of 60 minutes.
Alarm Setting

② Alarm Input

③ Alarm Output

④ Aux Output

➡

Alarm Output

Setting1 □1 □2 □3 □4 □MD □TRK

Setting2 □1 □2 □3 □4 □MD □TRK

 Timer	1	OFF
 Timer	1	OFF

-On : Retains an alarm output for a set duration from a minimum of 1 second to a maximum of 60 hours upon the alarm occurrence.

-Momentary : Retains an alarm output only until the alarm is canceled.

✽The Alarm Output is equipped with a relay circuit.The operation of the alarm output port is as shown in the diagram below.

NO		NO
COM	⇨	COM
NC		NC
Alarm Out OFF		Alarm Out ON

 Alarm Enable	OFF
② Alarm Input
③ Alarm Output
④ Aux Output
➡
AUX Output
 On/Off	OFF
 Time	00 SEC

NO	⇨	NO
COM		COM
AUX Off		AUX On

Notes

• Connecting the power connector and GND incorrectly to the NC/NO and COM ports may cause a short circuit and fire, damaging the camera.

• The maximum power capacity of the built-in relay is 30VDC/2A, 125VAC/0.5A, and 250VAC/0.25A. Operating the camera beyond the capacity may decrease the camera’s lifespan and damage it.

Notes

• Connecting the power connector and GND incorrectly to the Aux terminal’s NO and COM ports may cause a short circuit and fire, damaging the camera.

• The maximum power capacity of the built-in relay is 30VDC/2A, 125VAC/0.5A, and 250VAC/0.25A. Operating the camera beyond the capacity may decrease the camera’s lifespan and damage it.

SPEED DOME CAMERA 72 User’s Manual SPEED DOME CAMERA 73 User’s Manual